Stairmaster HIIT UBE User manual

HIIT UBE
ASSEMBLY INSTRUCTIONS
For Installation assistance or missing parts, please call CORE Health & Fitness at 1(800) 503-1221Document # 620-8574 Rev. B PAGE 1 OF 2
STEP 4: Install the user’s left side handle and secure it
using a 33-37 ft-lbs (48 Nm) 6mm allen key to tighten
the M8 axle screw into the handle.
STEP 5: Attach the removeable seat to the mast by locking the
seat hooks onto the mast mounting point, then rotating the seat
down into position.
STEP 6: Install the water bottle holder onto the mount
using a 5mm allen key to secure two (2) pieces each of
the M8 x 20mm screws and M8 washers. Then install
the mount onto the unit’s frame using two (2) pieces
each of the M8 x 20mm screws and M8 washers.
STEP 1: Slide the HIIT UBE base onto the mast then
use a 8mm allen key to secure the base onto the mast
using two (2) pieces each of the M10 x 40mm screws
and M10 washers.
STEP 2: Using a 8mm allen key, finish securing the base to the
mast using seven (7) pieces each of the M10 x 55mm screws and
M10 countersunk washers. Finally, use a 3mm allen key to install
two (2) pieces of the M5 x 10mm screws near the edge of the
base.
STEP 3: Secure the baseplate to the base using a
3mm allen key and two (2) pieces of the M5 x 10mm
screws.

HIIT UBE
CONSOLE ASSEMBLY INSTRUCTIONS
For Installation assistance or missing parts, please call CORE Health & Fitness at 1(800) 503-1221Document # 620-8574 Rev. B PAGE 2 OF 2
STEP 2: Before mounting the console to the unit,
gently pull the data cable from the mast then connect
the end of the data cable to the console. NOTE: Be
sure to feed any slack data cable back into the mast.
STEP 3: Use a 3mm allen key to secure the HIIT
Console to the mount using four (4) M5 x 14mm screws.
STEP 4: After installing the console, ensure that the unit type is set for
the appropriate model:
Power the console on by pressing the counter-clockwise arrow.
Press and hold the level up, level down, and clock buttons at the same
time for 3-5 seconds.
Use the down arrow to navigate to the 3rd page and press the clock
button to change between the following:
P1 “tread” - HIITMill and HIITMill X
P2 “bic1” - HIIT Bike
P3 “ergo” - HIIT UBE
P4 "Step" - Not Used Currently
P5 “bic2” -Airfit Bike
P6 none - Not Used Currently
Press the counter-clockwise arrow button to save the unit type.
LR14 1.5V
STEP 1: Use a #2 phillips screwdriver to remove the
locking screw securing the battery drawer inside
the console. Remove the battery drawer then
install two (2) LR14 1.5V batteries into the drawer.
Finally, reinsert the battery drawer and reinstall
the locking screw.