Stanley SXLS35527E User manual

Technical Data
Supply Voltage: 220-240 V ~ 50/60 Hz
Bulb Type: Non-replaceable 50W LED
(See rating / box info)
The light source contained in this luminaire
shall only be replaced by the manufacturer or
his service agent or a similar qualified person.
Class I product, must be connected to earth.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or local store for recycling
advice.
SXLS35527E - 50W
50W LED Worklight
Instruction Manual
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE
The thick and thin horizontal line field and the engineering plan packaging design are trademarks
of Stanley Tools.
CUSTOMER SUPPORT:
For customer service please visit the Online Customer Service Centre at: www.2helpU.com
© Stanley Black & Decker, Inc.
STANLEY and the STANLEY Logo are trademarks of Stanley Black & Decker, Inc or one of its afiliates,
and are used under license.
Products are manufactured by:
Cascade Holdings Ltd.
Gorse Mill, Gorse St
Oldham, OL9 9RJ U.K.
www.stanleytools.co.uk
2-YEAR LIMITED WARRANTY
The warranty of this product is covered by Cascade Holdings Ltd.
Conformity with all relevant UK & EC Directive
requirements.
IP65 Totally protected against dust.
Protected against low pressure jets of water
from all directions. Limited ingress permitted.

READ ALL INSTRUCTIONS
Safety
• These instructions are for your safety. Please read through them thoroughly prior to installation
and retain them for future reference.
• Always organise cables and extension leads so that they will not be a trip hazard.
If the external flexible cable or cord of this luminaire is damaged, it must only be replaced by
a qualified electrician to avoid any electrical hazards.
•
• Check the pack and make sure you have all of the parts listed.
• Remove all packaging, wrap etc. from the product.
• Decide on the appropriate location for your product.
• IP65 product: Totally protected against dust. Protected against low pressure jets of water
from all directions. Limited ingress permitted.
• Always refer to the installation drawing for the orientation of the product.
• Never put anything on the product or hang anything on any part of this product.
• When the product does not light after installation:
> Ensure there is no electricity failure
> Ensure all the connections are secured
• Always disconnect the product from mains at least 10 minutes allowing to cool down before
any maintenance or adjustment.
• CAUTION: Do not stare at the operating LED light source.
Cleaning care
• The lamp can be cleaned with a clean dry cloth. Do not immerse it in water.
• Always switch off the supply before cleaning.
Parts Supplied
x1
Installation Instructions
Images for illustration purposes only – Product may differ slightly from the one shown
plug-in
Unfold the stand
Multi-direction rotating can meet more requirements.
Side and bottom knobs for easy light head and stand
adjustment.
210°
90°