Start Label Dispensers LD7500 User manual

LD5500, LD7500
Electric Label Dispenser
42
31
Feed Labels
A: Pull label liner under guide bar
between guide rings
Feed Label Tape
Under Brush
A: Feed label liner in between brushes
and strip plate
Dispenser
A: Pull label liner over strip plate
separating liner from label
Load Label Roll
A: Insert core holders (2) into each side
of your label roll
B: Slide loaded roll onto the reel hanger bar
C: Slide material guide onto reel hanger
bar, tighten lightly using tension screw
ITEMS INCLUDED
A
Separate Liner
A
A
A
B
Core Holders (2)
Material Guide
Power Cord
Hex Wrench
C
LD5500,7500 Quick_Start_Guide_b0Page 1 5/19/2008 9:32:01 AM

8
75
6
Remove Lock Rod
Secure Liner Plug In Turn On
A: Slide lock rod off of take-up hub
A: Slide lock rod back onto take-up
hub to secure liner
B: Adjust / lower wIngscrew to create tension
on label liner
A: Connect power cord (in back)
B: Press power switch (on front) to turn
on the machine
Adjust Sensor
A: Loosen wingscrew (on side) to adjust
sensor plate
B: Point sensor towards edge of label
C: Tighten wingscrew to secure in place
LD5000
LD5500, LD7500
A
B
Quick Start Guide
4270 Airborn Dr. Addison, TX 75001, USA
972.248.1999 | [email protected]
startinternational.com
Need more help? Download the full manual or contact us
A
A
B
A
C
B
Q8.2