Steelcraft 40-15020 User manual

4X SIDEBARS
2021-22 FORD BRONCO 4DR
Page 1of 3 8/23/21 (AL)40-
PARTS LIST:
1
Driver/Left PNC Sidebar
12
10mm x 30mm Hex Bolts
1
Passenger/Right PNC Sidebar
12
10mm Lock Washers
2
Front Mounting Brackets
12
10mm x 27mm OD x 3mm Flat Washers
4
Center/Rear Mounting Brackets
12
8mm x 25mm Combo Bolts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
2. Starting from underneath the Passenger/Right body panel, locate the front mounting location and the
threaded holes in the body panel, (Figure 1). Remove the plastic plugs covering the holes.
3. Select the Passenger/Right Front Mounting Bracket. Attach the Mounting Bracket to the front location
with (2) 10mm Hex Bolts, (2) 10mm Lock Washers and (2) 10mm Flat Washers, (Figure 2). Do not
tighten hardware.
4. Repeat Steps 2 & 4 to attach (2) Center/Rear Mounting Brackets to the center and rear locations,
(Figures 3—5). Do not tighten hardware.
5. Select the Passenger/Right PNC Sidebar. Place the Sidebar onto the cradles of the Mounting Brackets.
IMPORTANT: Do not rotate or slide the Sidebar front to back or damage to the finish may result. Attach
the Sidebar to the Mounting Brackets with (6) 8mm Combo Bolts, (Figure 6). Do not tighten hardware.
6. Level and adjust the PNC Sidebar and tighten all hardware.
7. Repeat Steps 1—7to attach the Driver/Left PNC Sidebar.
8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the
finish. Mild soap may be used to clean the Sidebars.
Front
Passenger/Right
PNC Sidebar
(2) Front Mounting
Brackets
(4) Center/Rear
Mounting Brackets

4X SIDEBARS
2021-22 FORD BRONCO 4DR
Page 2of 3 8/23/21 (AL)40-
Passenger/Right side Installation Pictured
(Fig 1) Passenger/Right front mounting location
Front
(Fig 3) Passenger/Right center mounting location
Front
(Fig 2) Attach the Passenger/Right Front
Mounting Bracket to the front location
(2) 10mm Hex Bolts
(2) 10mm Lock Washers
(2) 10mm Flat Washers

4X SIDEBARS
2021-22 FORD BRONCO 4DR
Page 3of 3 8/23/21 (AL)40-
Passenger/Right side Installation Pictured
(Fig 6) Attach the Passenger/Right
Sidebar to the Mounting Brackets
Front
(Fig 5) Passenger/Right rear mounting location
(2) 8mm Combo Bolts
Rear
(2) 10mm Hex Bolts
(2) 10mm Lock Washers
(2) 10mm Flat Washers
(Fig 4) Attach (1) Passenger/Right Rear
Mounting Bracket to the center location