Stil-fit ESSENCE User manual

Fitness I Design I Interior
Assembly instruction STIL-FIT Functional Trainer
ESSENCE
PURE

Important
The functional trainer is already preassembled.
Don‘t change the position of the pulleys and the
pull out unit at the front.
Please follow all steps as shown.
The frame can be xed to the wall to the wall at
the top- and bottom part.
Use suitable stuts and screws to x the functional
trainer steady. The 4 adjustable feet allow to bring
the unit in a vertical position.
Using a lat unit please note:
Please assemble the lat unit to the
top
after you have xed the unit to the
wall.
1
points to scew the unit to the wall

Assembly of the weight plates
Remove the cross bar and the selector bar
The weight plates can be slided from top on to
the tubes.
Start with the large plates - totally 14 plates.
Note!
The grooves for the sticker are at the right side.
Mount the small plates
Assemble the selector bar with the top plate
Note: The groove with the label shows to the
front
Assemble the cross bar again
Mount the pulley to the socket of the selector
bar.
Attention - The cable should not twist.
1
2
3
4
5
6
3
56
cross bar
selector bar
4

Function test
Stick the silver pin into the second weight plate
and pull at the front unit.
If the pin cannot be sticked into the selector bar
smoothly the cabls are too tighten.
At the left top side of the frame there is an adjusta-
ble screw to adjust the length of the cable.
Check if all cable move perfectly.
Check if the front unit at the right and left side
move properly.
Put on all stickers of the weight plates.
Insert the front panel.
Put the panel at the bottom side on to the frame rst
and skip it forward.
Pay attention to the gap at both sides.
Assemble again the front handle.
4
7
9
8

4
5
10
Assemble the handels
12
Check if verything works smoothly.
Check if the front unit can be xed well by the clamp.
Try to move by hand the unit downwards. This should
not be possible. If you can move the unit tigthen the
screw under the lever a little bit and try it again.
When the lever is open the unit should slide easily on
the rail.
13
Assemble the side panels with screws from the
rearside.
The right and left panel is identical.
Version ESSENCE with mirror front:
Screw the front to the frame a the top
with 2 screws using the plastic cap.