Stil-fit ESSENCE User manual

Fitness I Design I Interior
Assembly instruction STIL-FIT Functional Trainer
ESSENCE
PURE

Important
The functional trainer is already preassembled.
Don‘t change the position of the pulleys and the pull
out unit at the front.
Remove the cable ties not before the assembly is
completed.
Please follow all steps as shown.
The frame has 4 mounting plates to fix the unit to the
wall.
Use suitable stuts and screws to fix the functional
trainer steady. The 4 adjustable feet allow to bring the
unit in a vertical position.
1
mounting plate

Assembly of the weight plates
Remove the cross bar and the selector bar
The weight plates can be slided from top on to the
tubes.
Start with the 3 cartons A - totally 14 plates.
Note!
The grooves for the sticker are at the right side.
Mount the small plates
Assemble the selector bar with the top plate
Note: The groove with the label shows to the front
Assemble the cross bar again with the 4 M6 screws.
Mount the head screws at the front to blind the
thread.
Remove the cable ties of the pulley for the selector
bar and mount the pulley to the socket of the
selector bar.
Attention - The cable should not twist.
Remove all cable ties of the unit.
1
2
3
4
5
6
7
3
cross bar
selector bar
selector bar pulley

Function test
Stick the silver pin into the second weight plate and
pull at the front unit.
If the pin cannot be sticked into the selector bar
smoothly the cabls are too tighten.
At the left top side of the frame there is an adjustable
screw to adjust the length of the cable.
Check if all cable move perfectly.
Check if the front unit at the right and left side move
properly.
Put on all stickers of the weight plates.
Insert the front panel.
Put the panel at the bottom side on to the frame first and
skip it forward and press it on to the extrusion profiles. The
panel is fixed by the velcro strap on top and bottom side.
Pay attention to the gap at both sides.
Assemble again the front handle.
4
8
10
9

Assemble the side panels to the frame.
The velcro shows to the wall side.
4 5
12
11
Assemble the handels
13
Check if verything works smoothly.
Check if the front unit can be fixed well by the clamp.
Try to move by hand the unit downwards. This should not
be possible. If you can move the unit tigthen the screw
under the lever a little bit and try it again.
When the lever is open the unit should slide easily on the
rail.
14
Assemble the side panels with M6 screws from the
rearside.
The right and left panel is identical.