
STM AUSTRALIA
1/615 WARRIGAL RD
ASHWOODVIC 3147
AUSTRALIA
T 1300131 531
F 1300308 508
E ENQUIRIES@STM.NET.AU
W WWW.STM.NET.AU
HRAWE3815 ABS Air/ Water Hose Reel Enclosed 3/8" x 10m
Wall Ceiling
WARNING
Before use, please note and understand all the contents of the specification, before you use it. Internal containing spring,
Prohibit non professional personnel to open, failure to comply with these instructions could result in personal injury or
property damage.
OPERATION
Before using, please check equipment for anomalies, if have, please stop using immediately.
When using, slow uniform alternating hands out to the force (about 3 kg) suitable length, and the ratchet brake locking, high
speed and damage of excessive tension can make the product. When using should be avoided in the process of tube
bending, trample, avoiding sharp objects
Recycling hose, the hose must be slowly pull out 8 to 30 cm, after the ratchet wheel brake from locking state, holding the
hose with the hand, make its slow recovery.
Note: it is strictly prohibited to the automatic recovery, in case of too fast causing bodily injury and damage to the
equipment.
DAILY MAINTENANCE
In order to ensure proper recycling of the hose, please make use of the cloth dipped in warm water pipes to remove surface
dirt. Please do not use may damage the pipe cleaners or solvents.
SHIPPING
During loading and unloading, forbidden still cast, fall, and trample, transport process, should avoid direct sunlight, rain,
contact with corrosive materials and conventional is prohibited.
INSTALL
Open the package and check if there is any damage to the
hose reel. The hose reel have to install in a reasonable
working environment.
Reasonable installation according to the drawings.
Remove the floor installation, the installation firstly
floor needs to be installed at a fixed location, product
support card again into the installation of floor chute,
tighten the bolt.
Product fixed and swing switch.
The product was originally a fixed type, remove the
A, B bolts, then C, D is swinging the fixed axis.
CA
B
D