Stratco HT-6549 User manual

THANK YOU FOR PURCHASING YOUR 1 DOOR METAL LOCKER UNIT.
Please carefully read and follow these instructions to assemble your cabinet.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
Step 1
JUN 2022
H T- 6 5 49
1
FOR INTERNAL USE ONLY
1 DOOR METAL
LOCKER UNIT
Slot front door panel into one
side then into the other.
Note: Ensure the front door
panel is flush with the side
panels. This is easier to do with
the doors open.
Top View
Bottom View
Screw together
back panel and
right hand side
panel at locations
indicated by the
arrows.
Screw together
back panel and
left hand side
panel at locations
indicated by the
arrows.
FITTING SIDE
PANELS TO
BACK PANEL
FITTING FRONT
DOOR PANEL
TO SIDE PANELS
Step 2
A
B
C

2JUN 2022
FOR INTERNAL USE ONLY
H T- 6 5 49
1 DOOR METAL
LOCKER UNIT
FITTING THE
BOTTOM PANEL
TO THE CABINET
Step 4
Push the floor panel down
inside the cabinet ensuring
the sides of the floor slide
into the slots on the side
and back panels. Ensure that the tab on the
bottom panel fits over the
lip on the front panel and
clips into place.
Finished size:
1850 x 380 x 450mm
F
G
FITTING THE
TOP PANEL
Step 3 EScrew the top panel to the
inside of the cabinet as
indicated by the arrows.
DSlide the top panel inside the
cabinet and push up until
flush with the top of panels.