Streamline CAST IRON SINK Series Programming manual

streamlinebath.com
QUESTIONS ON PRODUCT, INSTALLATION, RETURNS? PLEASE CONTACT
1 (310)-935-0028
[e-mail]
READ ENTIRE INSTALLATION GUIDE
PRIOR TO INSTALLING THE BATHTUB
THIS BATHTUB SHOULD ONLY BE
INSTALLED BY A CERTIFIED PLUMBER
CAUTION! TWO PEOPLE ARE REQUIRED
TO LIFT THE BATHTUB
CAST IRON SINK SERIES
OWNER'S MANUAL &
INSTALLATION GUIDE

These products must be installed by a fully insured and licensed plumber only.
Installation of any product by anyone other than fully insured and licensed plumber shall void limited warranty.
We are not responsible for any local code compliance for this product.
Building and plumbing codes may vary state-to-state.
Streamline shall not be held liable for any and all incidental damages or flood caused due to use of this product.
Streamline shall not be held liable for any and all fees stemming from cost of installation, re-installation, removal,
subsequent damage, or transportation in a case of a product defect.
Silicone
Jigsaw Drill
Sink
Measuring Tape Safety Glasses
Pencil
PRIOR TO INSTALLING
TOOLS REQUIRED
WHAT'S IN THE BOX

WALL MOUNT SINK INSTALLATION
1. Verify that there is enough cabinet clearance to install the sink.
2. Take proper measurements of the sink and then cut along the inside/ self-rim line of the cabinet.
3. Install the faucet and drain according to the manufacturer's installation instructions.
4. Drill pilot holes along the counter-top and then proceed to cut an opening on the counter-top.
•Only an experienced installer should install this product.
•This product does not come with a tap and drain, so please refer to the manufacturer's installation
instruction that you purchased the tap and drain from.

5. Ensure that the sink fits properly in the cutout. Adjust the cutout space if needed
6. Connect the drain to the plumbing in the home according to the manufacturer's instructions.
7. Apply silicone sealant along the edges to seal the connection. Wipe away any excess silicone that is
left over.
8. Test the water & drain connection by running the tap and checking for leaks.