Strymon cloudburst User manual

Controls
ambient reverb
1. DECAY
Controls the decay time of the
reverberated signal. Lower
settings reduce the size of the
reverberated space.
2. ENSEMBLE
Analyzes the input signal and
generates a harmonically rich pad
reminiscent of a string section:
o
no ensemble eect
A medium amount of ensemble
for a subtle enhancement
Maximum ensemble eect
creating a lush soundscape

Controls - continued
3. MIX
Controls the reverb mix from full
dry at minimum to full wet at
maximum. A 50/50 mix occurs
at approximately 3 o’clock on
the knob.
4. PRE-DELAY
Sets the amount of time before
the reverberated signal appears.
For most natural results, use
lower MIX settings when using
higher PRE-DELAY.
5. TONE
Adjusts the high-end content of
the reverb. Lower settings create
darker, warmer reverberation.
Higher settings are bright & crisp.
NOTE: Also aects the presence
of the ENSEMBLE eect.
6. MOD
Adds a wide range of
modulation to the reverberated
signal. Modulation is o at the
minimum setting.
7. FOOTSWITCH
Engages and disengages the
eect. Red LED indicates the
eect is engaged.
Support
Download the Full User Manual
strymon.net/support/cloudburst
Questions & Technical Support
[email protected]

Rear Panel
mono
1. I/O MODE SELECTOR
mono
mono input, mono output
mono stereo
mono input, stereo output
stereo
stereo input, stereo output
Stereo I/O requires a TRS adapter or
cable. See User Manual for details.
2. USB
Computer connection for MIDI I/O
and firmware updates.
3. INPUT
High impedance, ultra low-noise,
discrete Class A JFET stereo preamp .
4. OUTPUT
Low impedance TRS stereo output.
5. EXP/MIDI
Communication jack for external
control. Can be set to operate in
one of five modes: Expression
Pedal, Favorite, Freeze, Infinite, or
MIDI. See User Manual for details.
6. 9VDC
Only use an adapter with the
following rating: 9VDC, center-
negative, 250mA minimum (sold
separately).

Sample Settings
MIX
MIX
MIX
MIX

Designed and built
in the USA
Rev A