Sub-Zero 7001575 User manual

7001575 - UC Door Lock Kit Instructions
7014581 / Rev B / August, 2011
CONTAINS: QTY DESCRIPTION
1 Lock, Door w/ Keys and Nut
1 Cam, Lock (Offset Cam)
4 Screw, #10-24x1/2 Tamper Proof
Appliance can be laid on its back to allow easier installation of these components, but not neseccary. If
appliance is laid on its back, be sure to use proper lifting techniques. When done with component instal-
lation be sure to allow unit to stand upright a minimum of 24 hours before connecting power. This will
allow the oil to return to the compressor.
PROCEDURE:
1. Remove kickplate by extracting its mounting
screws from each side, then pull kickplate forward
(See Figure 1).
2. Remove switch depressor from bottom of door by
extracting its two mounting screws, then pull
switch depressor from door (See Figure 2).
3. Remove switch bracket from cabinet bottom by
extracting its two mounting screws, one each
side, then pull switch bracket down and forward
as far as wires will allow (See Figure 3).
NOTES:
•This is a very tight space. An offset screw-
driver will make this task easier.
•It is not neseccary to disconnect eletricals
from switch, but doing so will make lock
installation easier.
Page 1 of 2
QTY DESCRIPTION
1 Kickplate, Stainless Steel
1 Kickplate, U/C 24 (Black)
1 Instructions
Figure 1. Kickplate Removal
Figure 3. Switch Bracket Removal
Figure 2. Switch Depressor Removal
NOTE: Door and
Switch electricals
were removed from
diagram for clarity.
SHOCK HAZARD! DISCONNECT POWER TO UNIT BEFORE ATTEMPTING TO THIS PROCEDURE.
DOOR
NOTE: This lock kit can also be used on the model 424 if the serial number prefix is a “P”. If the serial number
prefix is an “M” or an “F” this lock kit will not fit.

7001575 - UC Door Lock Kit Instructions
7014581 / Rev B / August, 2011
4. Insert lock tumbler with trim ring into front of
switch bracket (See Figure 4).
5. Install nut onto back of tumbler, but do not tighten
nut at this time (See Figure 5).
6. Secure offset cam to rear of tumbler using lock
washer and screw provided. Make sure offset is
forward and in line with slot in switch bracket.
(See Figure 6).
7. To ensure offset cam/ lock is properly positioned,
insert the key into the tumbler and test the action
by turning the key (See Figure 7):
a. The offset cam should rotate upward through
the slot in the switch bracket and stop at the
12:00 o’clock position.
b Adjust tumbler to proper position as needed,
then fully tighten nut that holds tumbler to the
bracket at this time.
8. Reinstall switch box assembly, reusing mounting
screws removed earlier.
9. Reinstall switch depressor using the tamper proof
screws provided.
10. Select proper kickplate that comes with this pack-
age (modified for the lock), then install kickplate
on unit with mounting screws removed earlier.
11. Remember:
If unit has been laid on its back for this lock kit
installation procedure, allow the unit to stand
upright a minimum of twenty-four (24) hours
before applynig power to the unit. This will allow
the oil to return to the compressor.
Page 2 of 2
Figure 4. Lock Tumbler Installation
Figure 7. Lock Functioning Properly
Figure 5. Nut Installation
Figure 6. Offsetcam Installation