
Step guard RH
(Rear door sill
step guard-RH)
2
Completiondrawing Thecompletiondrawingandinstallationproceduresshowhowto
installtheRH(Righthand)sidestepguard.TheLH(Lefthand)side
installationcanbecarriedoutinthesamemannerastheRHside.
Installationprocedures
Rear seat cushion Side sill trim
Side sill panel
1)
Useisopropylalcoholtoremovedirtadheringtotheentiretopsurfaceofthesidesilltrim,anddrythoroughly.
2)Applymaskingtapetothetwoareasseparatedby12mmfromtheoutsideofthetrimpatternas
showninthefigurebelow.
Side sill trim
12mm
12mm
Masking tape
Front of the car
1)Refertoimagebelow.Fullyremove8ofthedouble-sidetapereleasefilmonthebackofthestep
guard.Onthetwolongpiecesoftape(#1and#2),partiallypeelandfoldbackabout70mmofthe
releasefilm.Seecautionnoteonfoldbacksequence.
2)Byreferringtothefigurebelow,alignthetopandfrontendsofthestepguardwiththetwopieces
ofmaskingtapedescribedintheprevioussection,andaligntherespectivethreelineslocatedon
therearedgeofthestepguardandthesidesilltrim,andthenattachtheguardtothetrimwith
double-sidedtape.Onceintheproperposition,slowlyremove#1and#2releasefilmwhilechecking
straightness.
3)Inordertocarryoutpressurebonding,applyweighttotheproduct(usethepalmofyourhandto
applyaforceof50Norhigher).
4)Removeallpiecesofmaskingtapeandtouchtheouteredgeofthestepguardtoconfirmthat
thereisnopeeling.
5)InstalltheLHsidestepguardinasimilarmanner.
Peel and fold back about 70mm. Tip: Crease the release film to help it stay.
CAUTION: Fold #1 first and then #2 as shown, otherwise #1 may become trapped.
Once the part is properly positioned, remove #1 and #2 slowly while checking straightness.
#2
#1
Side sill trim
Use the respective three lines for alignment.
Peel off the film in advance.
(8 pieces)
Dashed line: Double-sided tape
Ensure that the guard is parallel to the trim.
1.Cleanthesidesilltrim'ssurfacetowhichthestepguardistobeattached,
andapplymaskingtapetopositionthestepguard.
2.Attachthestepguardtothesidesilltrim.