Subaru J101SAN800 User manual

DESCRIPTION: LEGACY/OUTBACK Body Side Molding
5
J101SAN800
SPN0003268 3-21-19

5
Locate the body feature line on both front and rear doors. The
bottom of molding location template lines up to it. The body
feature lines are common on Legacy and Outback.
Front Feature Line Rear Feature Line
SPN0003268 3-21-19

5
Position the rear body side molding location template in place as shown.
Make sure the template is aligned with front edge of rear door and
center of body feature line. Then check the top tab mark so that it lines
up with door gap, place tape over the cut out holes (5).
LEGACY OUTBACK
Tab Mark
Body
Feature Line
Cut Out
Tape Holes (5)
Tab Mark
Body
Feature Line
Cut Out
Tape Holes (5)
Tab Mark Body
Feature Line
Cut Out
Tape Holes
Cut Out
Tape Holes (6)
Body
Feature Line
Body
Feature
Line
LEGACY
OUTBACK
Cut Out
Tape Holes (6)
Body
Feature
Line
Position the front body side molding location template in place using
locking profile as shown. Make sure the template is aligned with rear
lower edge of front door and centered on body feature line.
SPN0003268 3-21-19
Door Gap
Door Gap

5
Exposed Tape
LEGACY
OUTBACK
SPN0003268 3-21-19
Remove tape liners from backside of body side moulding, using
tabs start with horizontal to end pieces. Then shaped pieces with
and without blue tape. DO NOT TOUCH EXPOSED TAPE
Blue Film Tape
& Folded Tab

5
7
8
9Repeat steps 1 through 8 on passengers side of vehicle, using
other side of paper template.
5
SPN0003268 3-21-19