
• Newborn Sling: Rinse sling with clean, warm water and mild soap. Air dry.
• Tub: Clean with a damp cloth, mild soap, and clean warm water.
• Make sure all screws on the battery compartment are tight.
• Do not use product if any components are damaged.
• Remove batteries before any long storage periods.
cleaning, maintenance & storage
secure to single or double sink:
to use in adult tub: draining the tub:
!
IMPORTANT: ALWAYS
keep the drain open in
the adult tub!
Pull plug
to drain tub.
Place tub
securely on the
oor of an adult tub.
!
IMPORTANT: Shift tub to one side as far as it will go and push down rmly to
conrm tub stability. Shift tub in the opposite direction as far as it will go and
push down rmly to reconrm tub stability.
Use notch on the tub’s
base to secure to the
divider on double sinks.
Seat the base of the tub
into a single sink.
CAUTION: ALWAYS test for a secure t in
the sink before placing baby in tub.
!
Please retain information for future reference. Colors and styles may vary.
Made in USA with U.S. and imported components.
Summer Infant (USA), Inc. 1275 Park East Drive Woonsocket, RI 02895 USA 1-401-671-6551
www.summerinfant.com © 2018 Summer Infant (USA), Inc.
05/18
submarine sprayer toy setup (continued):
If your sprayer is not working, follow the below steps:
1. Turn sprayer o.
2. Straighten out hose (Figure A) and submerge both ends of the sprayer just
beneath water level (Figure B). Be sure to keep the hose straight and submerged
during this process.
3. Turn sprayer on with both ends submerged, sprayer should start to produce
bubbles. Once bubbles are visible, the sprayer is ready for use.
4. Turn sprayer o and mount to tub wall (Figure C).
5. Once mounted, turn on sprayer for regular use.
NOTE: It may take a few seconds for the sprayer to produce bubbles.
For best use, DO NOT overbend the hose.
To remove the sprayer from the tub:
1. Pull tabs on suction cup (Figure D) to release from tub wall.
A B
C D