Sunco SHOEBOX 150W User manual

1
EASY INSTALLATION
DIMMING OPTIONS
COMPONENTS
WIRING DIAGRAM
Optional: To dim light, connect a compatible dimmer switch (not included) to wires in
fixture as shown. Choose appropriate dimming method:
1. Constant current can be achieved by 1-10VDC dimming.
2. PWM signal dimming.
3. Variation of resistance unit dimming.
Adjustable Slip Fitter (AM) Mounting For Round Poles
Required Tools: Drill, Ladder, Hammer, Wrench, Tape Measure, Pencil
Turn Power
OFF
Fixing
Base
Lamp
Holder
SHOEBOX W/W
PARKING LOT LED LIGHT
Locking Bolt
Locking Bolt Turn Power
ON
°
Black/Brown:ACL
Green/Yellow
White/Blue:ACN
PINK: DIM -
PURPLE: DIM+
BLACK/BROWN: ACL
GREEN/YELLOW
WHITE/BLUE: ACN
Installation Manual
1. Turn off circuit breaker that
provides power to light switch.
2. Use wrench to disassemble
slip fitter fixing base from lamp
holder.
3. Pull fixture wires through fixing
base as shown.
4. Tighten screws to attach fixing
base to shoebox light fixture.
5. Pull fixture wires through lamp
holder.
6. Use wrench to secure lamp
holder to fixing base.
7. Loosen (4) locking bolts on slip
fitter.
8. Connect supply wires to fixture
wires with wire nuts.
• Black to Black
• White to White
• Green to Green
9. Secure to pole by tightening (4)
locking bolts.
10. Turn on circuit breaker and test
light.
11. Adjust angle 0-90° to aim light
beam.
Adjustable Slip
Fitter (AM)
x1
Dusk to Dawn
Sensor
x1

2
EASY INSTALLATION
DUSK TO DAWN BEST PRACTICES
SPECIFICATIONS
This light fixture includes a Dusk to Dawn photocell sensor which controls light
operation based on ambient light levels. The sensor turns the light on in the absence of
light and turns it off again when light is detected. Please note:
• The fixture must be powered on continuously for the photocell sensor to function
properly.
• Ensure the fixture is not obstructed by a tree or building so the sensor can properly
detect available light levels.
• Do not place the fixture near other light sources or reflective surfaces. If a bright light
is detected in the area, the sensor will not turn the fixture on.
Voltage
Wattage
Wet Wet
Aluminum Alloy + PC Aluminum Alloy + PC
lbs.lbs
years years
VV
WW
Housing
Weight
Warranty
Moisture Rating
Installation Manual
WARNING
To reduce the risk of fire, electric shock, or physical injury:
• This product should be installed in accordance with regional and local laws or
regulations by a person familiar with the construction and operation of the product and
the hazards involved.
• Check for shipping damage prior to install. If the product is damaged, do not use it.
• Always turn o power to the switch and circuit breaker before installing a new light fixture.
• Proper grounding is required to ensure safety. Do not install this fixture in the rain.
• If you experience smoke or fire in the wires or lamps during or after installation, turn o
the power immediately and notify relevant personnel.
• Clean the fixture regularly to ensure proper operation. Do not clean with harsh solvents.
• Use safety precautions. Safety eyeglasses and gloves are recommended
Dusk to Dawn
Sensor
SHOEBOX W/W
PARKING LOT LED LIGHT
Adding Dusk to Dawn Sensor
1. Insert blue Dusk to Dawn sensor
into (3) curved slots on lamp top.
2. Twist unit clockwise to lock into
place.