Sunny NAU Series User manual

Test
Test
LED AC Indicate that the unit is receiving power.
LED Charge/Full Gives information on battery charging.
LED ON Indicate the unit is ready for operation.
Switch ON Press to turn on the lamp (while the unit is not plugged in).
Switch OFF Press to turn o the lamp (while the unit is not plugged in).
Switch Test For testing the device’s availability. (during normal circumstance)
1. Controlled by a highly intelligent 8-bit micro controller.
2. Using high quality LEDs with a lifetime of over 50,000 hours, providing bright and
constant illimitation throughout its operation.
3. The unit’s outer case is made from ABS UL94 V-O Flame Retardant plastic that is
highly resistant to impact and corrosion.
4. The Power ON function is designed for when the user wants to install the units in a
site that might not currently be ready. With this function the emergency lamp will
not yet activate and will not unnecessarily use up the lifetime of the battery.
USER MANUAL
Self-Contained Emergency Light NAU Series
Status Indicators and Testing Buttons
Features

1. The unit can be installed on leveled ground or hung up.
2. Install properly and securely to prevent accidents that could cause damage to the
unit or other people and property.
3. Press and hold the ON Switch for about 3 seconds. Both emergency lamps will
illuminate and the LED ON light on the unit will turn on indicating that the unit is
operational.
4. Plug the unit into a power socket with a 220Vac power supply. The emergency lamp
will remain on for about 5 seconds before turning o.
5. The AC LED light will show if the unit is receiving power from the power socket.
The Charge/Full LED will blink if the battery is charging and will remain on when the
battery if fully charged.
6. When the user is ready to put the unit into operation, the user can test the unit using
the Test button. The lamp on the unit will turn on for 5 seconds and then turn o.
After the test the unit will return to its normal operation mode.
1. Always press the “ON” switch every time after installation to turn on the unit.
2. When the unit is not in use always turn it o by pressing the “OFF” switch.
3. The unit should be installed indoors away from direct sunlight and rain or moisture.
4. The unit should be stored in temperatures under 25 Degree Celsius and the battery
should be charged every 3 months to maintain its operational life.
Installation and Operation
Important Note on Using the Unit

SIDE VIEWBACK VIEWFRONT VIEW
W 80
H 230
L 250
H 230
197
Test
L 250
H 230
- Power not getting to the unit
after plugging in.
The LED AC light does not
turn on.
- The power socket might not have
any power.
- The plug or socket is loose.
- The AC.220V fuse is blown.
- Check the 220VAC power supply.
- Check the plug and socket.
- Contact customer service.
- Emergency light does not
turn on after the power went
out.
- Emergency light only turns
on for a short time after the
power went out.
- The battery is not fully charged.
- The battery has degraded.
- Fully charge the battery.
- Contact customer service to
replace the battery
ProblemCause What to do
-The unit is not plugged in.
-Battery terminal not connected.
-The lamp is faulty.
-The circuit’s wiring is loose.
-The DC fuse is blown.
-Check that the unit is plugged in.
- Please connect the battery
terminals.
-Contact customer service.
-Contact customer service.
-Contact customer service.
Initial Trouble Shooting
Dimension (mm)

For any further questions about your product
please feel free to contact SUNNY’s customer
service department.
Tel. [phone]
E-mail: [email protected]
1. The product will only be under warranty if the customer fills in the “warranty card”
and return the “return part” to the company within 7 days of purchasing the product.
If this is not done within the specified time then the warranty will be considered void.
2. The warranty only covers the unit’s internal parts for the duration specified by the
company counting from the date of purchase.
3. Please show the warranty card every time when contacting our service department
or the dealer you purchased the unit from.
4. The warranty will be considered void in the following cases.
The unit has been used outside of its intended use specified in the manual.
The unit has been used with equipment that does not meet the specifications
specified within the manual.
The unit has been damaged from impact, for example parts are dented, scratched
missing or distorted.
The unit has been modified or repaired by people not ocially certified by our
company.
The Sticker Warranty Void has been removed or torn.
The unit is damaged from negligence or incompetent use, for example, the
battery is swollen, the batter has been overcharged, the battery has been
damaged from quick charging, the battery has been short-circuited, the battery’s
charged has been completely drained.
The unit has been stored improperly, for example, it was exposed to moisture
causing rust and damage to the internal circuitry.
Damaged was caused by a malfunction in the AC power supply.
Damage from natural disaster such as fire, moisture, submersion in liquids,
chemical damage or from unavoidable circumstances.
Damage from animals or insects.
Note : Please read the manual carefully before installation and operation to understand
how to properly operate the unit.
Terms for Warranty and Service
IsOn Import-Export Co., Ltd.
2915-2917 Ladprao Road, Klongjan,
Bangkapi, Bangkok 10240