Sunnydaze Decor ROUND GALVALUME STEEL RAISED GARDEN BED User manual

ROUND GALVALUME STEEL
RAISED GARDEN BED
Read all assembly and care instructions carefully before using this product. Save this manual for future reference.

Page 1 / 3
Thank you for choosing Sunnydaze Decor. We stand behind our brand and the quality of the items we sell.
Replacement parts or products will be sent at our discretion within the 1-year warranty period. Proof of purchase, with
the date of purchase as well as photos of the merchandise defect, must be provided. Photos are used to determine
the cause of defects and for future quality control. Register your warranty at https://tiny.cc/SunnydazeWarranty
If you have any questions, comments or concerns, feel free to contact us by phone at 833-982-1977, by email:
[e-mail], or via our contact us page at https://tiny.cc/SunnydazeContact
Purchase Date: / / Order/Customer Reference Number:
  
APanel 6
BM6x12mm Bolt Set 36
CEdge Trim 1
DScrewdriver 1
R9043 04/2022
Inspect packaging to ensure all
parts are accounted for before
disposing of packing materials.
CHOKING HAZARD — This item contains small parts that can be
swallowed. Keep children and pets away during assembly.
WARNING
WARNING:
Manufacturer and seller expressly disclaim any and all liability from personal injury, property damage or loss, whether direct or


Page 2 / 3
ASSEMBLY
R9043
STEP 1
A: 2
B: 6
STEP 2
A: 1
B: 6
STEP 3
A: 3
B: 24
Align one Panel (A) with the
assembled components and fasten
using six M6x12mm Bolt Sets (B).
Do not fully tighten hardware.
HELPFUL HINTS
Before assembly, lay the panels out to ensure all edges will align correctly, as
shown in the drawing to the right. If the edges are o󰀨set, switch or rotate the
panels until all align correctly. If the panel edges are not properly aligned, the
mounting holes will be di󰀩cult to align, and the Rubber Edge Trim will not install
correctly.
Do not fully tighten hardware until all components have been loosely assembled.
If hardware is tightened too soon, mounting holes may not align, and parts may not easily t together.
Repeat the previous step to
connect the remaining three Panels
(A) using the remaining twenty-four
M6x12mm Bolt Sets (B).
Fully tighten all hardware after
this step is complete.
NOTE: Before beginning assembly, read and
understand the Helpful Hints noted above.
Align Panels (A) and loosely fasten
using six M6x12mm Bolt Sets (B).
Do not fully tighten hardware.
04/2022

Page 3 / 3
WARNING!
Manufacturer and seller expressly disclaim any and all liability from personal injury, property damage
or loss, whether direct or indirect, or incidental, resulting from the incorrect attachment, improper use,

R9043

EDGE TRIM INSTALLATION (optional)
Begin Installation
Firmly push Trim Edge (C) onto the top side of the
garden bed.
Avoid leaving excess material as the trim edge is
pressed around the top side of the garden bed.
Removing Excess Trim Material
If there is excess trim, use the proper cutting tool
and feel for the gap between the clips.
There are metal clips segments embedded into
the plastic. If the spot between the clips is not
identied before cutting, the trim may crush when
making the cut. By nding the gap, the cut will be
clean.
Take care not to cut the trim too short.
Finishing Installation
All plastics, over time, will experience some
shrinkage, causing your trim edges to separate.
To complete the edging installation, leave a bit
more material on one side and push the ends
together. Press the extra material down to force
more material into the application so the trim is
not stretched.
04/2022