Super Circuits CD23VF User manual

Camera unit User manual Positioning stricker Mount plate Wrenches x2
1 2 3 4 5
Wall anchors plastic
sheath X3
Wall anchors X3 O-ring X4 Cable gland Terminal block Sponge rubber
6
7 8 9 10
DC jack
11 12
CD23VF

1/3” SONY CCD Sensor
NTSC: 510(H)*494(V) / PAL: 500(H)*582(V)
2.8~11mm V.F lens
420 TV lines
2:1 interlace
0.1 Lux/ F1.2
Internal
More than 48dB
0.45
Auto and up 1/100,000
1 Vp-p output, 75 Ohm Composite
DC 12V /AC 24V
400mA(MAX)
MCT-AWB Technology (Multi-color Temp.)
Full Auto
2H Mode of H.V aperture correction
500g
-30° ~ +60°C
-10° ~ +45°C
CD23VF
Full Auto
Full Auto
153.6mm * 147.2mm * 82.2mm
Attach positioning
sticker (P1/No.3) to
the wall.
Drill holes as
indicated and attach
wall anchors
(P1/No.6).
Use the T10 wrench
(P1/No.5) unscrew
the vandal screws.
Open the cover.
Take the mount
plate (P1/No.4),
Use anchor screws
(P1/No.7) to affix on
wall.
Align the red dots
on the mount plate
and bottom plate.
Rotate the bottom
plate in order to
combine the mount
plate.
Tighten the screws
after setup.
Adjust the zoom and
focus.
3-Axis Installation:
Loosen the screws
to adjust camera
direction, the vertical
angle is 15° to 90°.
Tighten the screws
after adjustment.
Loosen the screws
to adjust horizontal
angle, the angle is
+150°. Tighten the
screws after
adjustment.
Maximum range of
rotation adjustment is
350°.
Tighten the screws
after adjustment.
Caution: While
rotating object at
360°, the bottom
plate drops.
Adjust the illumination level.
Align the red dots on the base
and camera cover, then
tighten the vandal screws.