SuperATV TSK-CA-DEF-004 User manual

© 2018 SuperATV.com®. All Rights Reserved. IN-TSK-CA-DEF-004 10/29/2018
INSTALLATION INSTRUCTIONS
Read instructions and view illustrations before beginning.
Plug and Play Turn Signal Kit:
for Can-Am Defender
Wire Ties
Horn Kit
2753 Michigan Road • Madison, Indiana 47250 • 855-743-3427
Thank You
For Choosing
Need help with your installation?
www.superatv.com
8:00am - 9:00pm EST M-Th
8:00am - 7:00pm EST Friday
9:00am - 2:00pm EST Saturday
[e-mail]
1-855-743-3427
Hazard Light Switch Horn Switch Turn Signal Switch
#8-18 x 3/16” Lg. Screw2x
#8-18 x 3/4” Lg. Screw2x
M5-.80 Nylock Nut4x
M5-.80 x 16mm Lg. BHCS4x
4x - LED Signal
Control Box Bracket
Mounting Bracket
Components may be installed in locations other than where shown. Alway verify wire harness length.
M8-1.25 Nylock Nut4x
M8-1.25 x 20mm Lg. FHCS4x
(disregard any remaining hardware)

2
IN-TSK-CA-DEF-004
Front Harness
Main Harness
use provided dielctric grease
on all connections
Always consult labels on Wiring Harnesses
when making connections.
to passenger side
Rear Harness
to driver side
to License (if applicable)
to stock Harness
to Control Box

3
IN-TSK-CA-DEF-004
(passenger)
- Remove Front Bulkhead Cover.
- Remove Battery Cover.
Front Bulkhead Cover
Battery Cover
(passenger)
Floor Cover
- Remove Floor Cover.
(passenger)

4
IN-TSK-CA-DEF-004
- Secure Control Box to Bracket with provided M5 hardware.
provided M8 hardware
Control Box Bracket
Mounting Bracket
Control Box
- Join Control Box Bracket and Mounting Bracket with
provided M8 hardware; do not tighten completely.

5
IN-TSK-CA-DEF-004
Wiring Harness:
- Route Harness to Front and Rear of vehicle.
(passenger)
Harness to FRONT FRONT
Harness to REAR

6
IN-TSK-CA-DEF-004
connect 12V and Ground wires from
Harness to Accessory Power Block
(driver footwell looking under Dash)
Power Connections:
Accessory Power Block
Red (+)
Black (-)

7
IN-TSK-CA-DEF-004
Horn:
- UsermayinstallHorninlocationdi󰀨erentthanshown.
- Location must be protected from mud, debris, and water.
- Illustration is SuperATV’s choice.
drill Ø1/4” hole
- Connect Harness and install Horn.
- Secure with Nut provided in Horn Kit.
Horn Kit

8
IN-TSK-CA-DEF-004
LED Signal:
- Drill a Ø3/4” hole in body and install LED Signal. Repeat for remaining LED Signals.
- Plug LED Signals into corresponding inputs on Front Harness.
- Secure all Wires as needed.
LED
Gasket
- Separate LED from Gasket.
- Install Gasket into hole.
- Install LED into Gasket.
If Light is hard to insert separate as shown.
(passenger)
LED Signal
Before drilling any holes, check behind area to be drilled for any interference.
LED Signal

9
IN-TSK-CA-DEF-004
(driver)
remove
remove stock Seal from Tail Light
- Remove Tail Lights.

10
IN-TSK-CA-DEF-004
Rear Harnesses:
- Raise Cargo Bed and unplug stock harness in location shown.
(driver)
Stock Rear Harness connection is located on,
and under, passenger side Frame Rail
- Connect Rear Harness to stock Harness, as shown, and route to Tail Lights.
- Secure all Wires as needed.
(passenger)
Rear Harness
Stock

11
IN-TSK-CA-DEF-004
Actuator
TERMINAL 7 AND ARROW MUST BE ORIENTED AS SHOWN
Rotate Actuator 180°
- Gently pry one side up.
- Pry opposite up and remove Actuator.
- Rotate and snap Actuator into place.
Switch Orientation

12
IN-TSK-CA-DEF-004
Before drilling any holes, check behind area to be drilled for any interference.
use stock locations if available
Switch Mounting:
- UsermayinstallSwitchesinlocationsdi󰀨erentthanshown.
- Verify that Wire Harness will reach Switches before mounting.
use stock locations if available
if no stock locations are availabe, use provided template and cut slots for Switch mounting
SuperATV recommends testing Switches before permanently mounting.

13
IN-TSK-CA-DEF-004
- Install Mounting Bracket to Frame with provided M8 hardware; tighten completely.
provided M8 hardware
Mounting Bracket
- Reinstall stock components.

14
IN-TSK-CA-DEF-004
CUSTOMER NOTIFICATION AND DISCLAIMER LIABILITY
This product is a modication for utility task vehicles and all terrain vehicles. Use this product at your own risk.
Warranty and Liability Limitations. The Buyer hereby assumes all risks associated with the use and/or installation of this product. Buyer waives all liability claims against
SuperATV®ofanykindornature,including,butnotlimitedto,liabilityforpenalties,nes,propertydamage,personalinjuryordeath,tothefullestextentpermittedbylaw.Buyer
acknowledges and agrees that SuperATV®is not liable for any direct, indirect, incidental, consequential or special damages, including but not limited to, damage, loss of life, loss
ofpropertyorequipment,lossofprotsorrevenue,injury,orclaimsfromanyindividualorentityarisingfromtheuseofthisproduct.
Thewarrantyforthisproduct,ifany,maygiveyou(“Buyer”)speciclegalrights,andBuyermayalsohaveotherrightswhichmayvaryfromstatetostate.Theinstallationofthis
productmayvoidorotherwiseadverselya󰀨ectyourfactorywarranty.
Consult your vehicle warranty before using this Product. Under no circumstances will SuperATV®be liable for the voidance of the Buyer’s vehicle warranty. Buyer assumes all risk
and responsibility if a manufacturer and/or dealer voids the Buyer’s vehicle warranty due to use of this Product.
Safety and Laws.Operateyourvehicleatalltimesinasafemanner.Youmustabidebyalllocal,state,andfederallaws,includingbutnotlimitedtovehiclesafety,tra󰀩claws,
and ordinances. It is your responsibility to know the laws and how they apply to you. The installation of this product may violate certain local, state, and federal laws. Be advised
that laws vary depending on town, city, county, state, etc. Use of this product on public streets, roads, or highways may be in violation law. The Buyer is solely and exclusively
legally and personally responsible for any violation of the law by the installation or use of this product. In no case will SuperATV®be held liable if Buyer violates the law or uses
the product in an unsafe manner.
TheBuyerisresponsibletofullyunderstandthecapabilityandlimitationsofhis/hervehicleaccordingtomanufacturerspecications,warningsandinstructionsandagreestohold
SuperATV®harmlessfromanydamageresultingfromfailuretoadheretosuchspecications,warningsand/orinstructions.TheBuyerisalsoresponsibletoobeyallapplicable
federal, state, and local laws when operating his/her vehicle while using this product, and the Buyer agrees to hold SuperATV®harmless from any violation thereof.
Installation. The installation of this product on your vehicle indicates that you have had the opportunity to inquire about applicable local, state, and federal laws and ordinances
and that you have read and understand, and accept all of the terms of, this Disclaimer.
SuperATV®shall not be responsible for the proper installation, use, and service of this product. Rather, the Buyer shall be solely responsible for the installation of the product and
anydamagethatmaybedonetothevehicleorvehiclecomponentsasaresultofmodicationsmadebytheBuyer.
Switch Templates
1.450”
.830”
- Rear Harness has a connection for License Plate lighting. Connect License Plate Harness and
route as needed.