SuperATV ROOF-Y-WV-002 User manual

INSTALLATION INSTRUCTIONS
© 2016 SuperATV.com. All Rights Reserved. IN-ROOF-Y-WV-002 5/10/2016
Read instructions and view illustrations before beginning.
Need help with your installation?
1-812-574-7777
[e-mail] www.superatv.com
8:00am - 9:00pm EST M-Th
8:00am - 7:00pm EST Friday
9:00am - 2:00pm EST Saturday
Thank You
For Choosing
Tinted Roof: for Yamaha Wolverine
Liability Statement
SuperATV’s® products are designed to best t user’s ATV/UTV under stock
conditions. Adding, modifying, or fabricating any factory or aftermarket parts will
void any warranty provided by SuperATV®and is not recommended. SuperATV’s®
products could interfere with other aftermarket accessories. If user has aftermarket
products on machine, contact SuperATV® to verify that they will work together.
Although SuperATV® has thousands of satised customers, user should be aware
that installing lift kits, long travel, or suspension kits, tires, etc. will change the ride
of machine and may increase maintenance and part wear. Operating any off-road
machine while, or after, consuming alcohol and/or drugs increases risk of bodily
harm or death. No warranty or representation is made as to this product’s ability to
protect user from severe injury or death. SuperATV®urges operators and occupants
to wear a helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV®products, user agrees that should damages
occur, SuperATV®will not be held responsible for loss of time, use, labor fees,
replacement parts, or freight charges. SuperATV®, nor any 3rd party, will not be held
responsible for any direct, indirect, incidental, special, or consequential damages
that result from any product purchased from SuperATV®. The total liability of seller to
user for all damages, losses, and causes of action, if any, shall not exceed the total
purchase price paid for the product that gave rise to the claim.
SuperATV®will warranty only parts provided by SuperATV®. Any damage or
problems with OEM housings, bearings, seals, or other manufacturers’ products will
not be covered by SuperATV®. SuperATV®parts and products are not warrantied if
item was not installed properly, misused, or modied.
2753 Michigan Road • Madison, Indiana 47250 • 812-574-7777
M6 Washer4x
M6-1.0 Nylock Nut54x
M6 Sealing Washer54x
54x M6-1.0 x 25mm Lg. BHCS
4x Grommet
4x - 1.50" Clamp
(disassemble)
4x - 2" Clamp
Use hand tools only when assembling.
Do not use power tools.
(kit contents continue on following pages)
Gasket Flat Seal

IN-ROOF-Y-WV-002 2
A
C
B
D
E
J
L
G
F
K
H
(kit contents continued)
Item Description
A Rear Panel
B Right Panel
C Left Panel
D Center Panel
ERight Rear Bracket
FLeft Rear Bracket
GRight Bracket
HLeft Bracket
JRight Front Bracket
KLeft Front Bracket
LRear Bracket

IN-ROOF-Y-WV-002 3
install Grommets into holes in Panels
Tip: apply soapy water to Rubber Grommets.
A
C
D
B
8x
Reference Only; do not assemble at this time.
(driver)
(passenger)
front

IN-ROOF-Y-WV-002 4
Flat Seal installation: set aside when completed.
- Install provided Flat Seal to highlighted sections shown on Brackets (E-L).
Flat Seal
F
J
G
K
L
E
H
Item Description
ERight Rear Bracket
FLeft Rear Bracket
GRight Bracket
HLeft Bracket
JRight Front Bracket
KLeft Front Bracket
LRear Bracket
Reference

IN-ROOF-Y-WV-002 5
rear
14 each
Use hardware shown
when installing.
M6 Nut
Sealing Washer
M6x 25mm
C
D
K
H
Panel and Bracket installation:
- Join Center Panel (D) and Left Panel (C) to Left Bracket (H) and Left Front Bracket (K)
with hardware shown.
- Previously installed Flat Seals on Brackets must be against Roof Panels.
- Repeat for opposite side.
(passenger)
Rubber must face Roof Panels
when installing Sealing Washer

IN-ROOF-Y-WV-002 6
Panel and Bracket installation continued:
- Install Rear Bracket (L) to Center Panel (D) with hardware shown.
- Install Rear Panel (A) to Rear Bracket (L) with hardware shown.
- Join Rear Panel (A), Right Panel (B), and Left Panel (C) to Rear Bracket (L), Right Rear Bracket (E),
and Left Rear Bracket (F) with hardware shown.
- Previously installed Flat Seals on Brackets must be against Roof Panels.
22 each
Use hardware shown
when installing.
M6 Nut
Sealing Washer
M6x 25mm
B
(driver)
(passenger)
Rubber must face Roof Panels
when installing Sealing Washer
D
C
AL
E
F
rear

IN-ROOF-Y-WV-002 7
Clamp installation:
- Install Clamps to Roll Cage as shown.
1.50" Clamp
1.50" Clamp
2" Clamp
2" Clamp
(driver)
front
(passenger)
Previously removed hardware from 1.50" Clamps
M6 Washer M6 Nut
M6x 25mm
2" Clamp hardware x 4
front
Roof installation:
- Secure Roof to Clamps with hardware shown.
(passenger)

IN-ROOF-Y-WV-002 8
Roof Cleaning:
- Do not use window cleaning uids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, etc).
- Never use abrasive cleaners, abrasive pads, or gritty cloths.
- Never use razor blades, scrapers, sqeegees, brushes, etc.
1. Thouroughly rinse Roof to oat off dirt and mud.
2. Using a soft cloth, or microber cloth, clean Roof with warm water and a gentle detergent. Baby shampoo or hand
washing soap are recommended.
3.To prevent water spots, use a chamois to blot Windshield dry.