SuperATV Half Windshield User manual

INSTALLATION INSTRUCTIONS
© 2016 SuperATV.com®. All Rights Reserved. IN-HWS-CA-X3 10/12/2016
Read instructions and view illustrations before beginning.
Need help with your installation?
1-812-574-7777
[e-mail] www.superatv.com
8:00am - 9:00pm EST M-Th
8:00am - 7:00pm EST Friday
9:00am - 2:00pm EST Saturday
Windshield
SuperATV does not recommend keeping Windshield installed while transporting on an open air trailer.
Liability Statement
SuperATV’s® products are designed to best t user’s ATV/UTV under stock
conditions. Adding, modifying, or fabricating any factory or aftermarket parts will
void any warranty provided by SuperATV®and is not recommended. SuperATV’s®
products could interfere with other aftermarket accessories. If user has aftermarket
products on machine, contact SuperATV® to verify that they will work together.
Although SuperATV® has thousands of satised customers, user should be aware
that installing lift kits, long travel, or suspension kits, tires, etc. will change the ride
of machine and may increase maintenance and part wear. Operating any o󰀨-road
machine while, or after, consuming alcohol and/or drugs increases risk of bodily
harm or death. No warranty or representation is made as to this product’s ability to
protect user from severe injury or death. SuperATV®urges operators and occupants
to wear a helmet and appropriate riding gear at all times.
By purchasing and installing SuperATV®products, user agrees that should damages
occur, SuperATV®will not be held responsible for loss of time, use, labor fees,
replacement parts, or freight charges. SuperATV®, nor any 3rd party, will not be held
responsible for any direct, indirect, incidental, special, or consequential damages
that result from any product purchased from SuperATV®. The total liability of seller to
user for all damages, losses, and causes of action, if any, shall not exceed the total
purchase price paid for the product that gave rise to the claim.
SuperATV®will warranty only parts provided by SuperATV®. Any damage or
problems with OEM housings, bearings, seals, or other manufacturers’ products will
not be covered by SuperATV®. SuperATV®parts and products are not warrantied if
item was not installed properly, misused, or modied.
2x - Clamp
Seal
M6-1.0 x 20mm Lg. BHCS4x
Use hand tools only when assembling.
Do not use power tools.
M6 Sealing Washer4x
2753 Michigan Road • Madison, Indiana 47250 • 812-574-7777
Thank You
For Choosing
Half Windshield: for Can-Am Maverick X3

IN-HWS-CA-X3 2
Bulb portion of Seal to always face towards vehicle
Seal
Windshield
(passenger side)
- Install Seal to Windshield as shown.
- Before installing Seal, soak in hot water to increase exibility.
Sealing Washer
M6 x 20mm
2 each
Rubber must face Windshield
when installing.
Remove Clamp hardware;
set aside.

IN-HWS-CA-X3 3
Windshield Cleaning:
- Do not use window cleaning uids (Windex, 409, etc) or any solvents (gasoline, denatured alcohol, acetone, etc).
- Never use abrasive cleaners, abrasive pads, or gritty cloths.
- Never use razor blades, scrapers, sqeegees, brushes, etc.
1. Thouroughly rinse Windshield to oat o󰀨 dirt and mud.
2. Using a soft cloth, or microber cloth, clean Windshield with warm water and a gentle detergent. Baby shampoo
or hand washing soap are recommended.
3.To prevent water spots, use a chamois to blot Windshield dry.
- Place Windhield onto Cage and secure Clamps with included hardware.
- Tighten hardware completely
(passenger side)
included with Clamps