supremo LEISURE Belfort User guide

Belfort

Y shape connector
with RGB control unit
Control box
+LED
+LED
+LED
AB/BC/CD/DA
Battery not included
SPECIFICATION OF CONTROL BOX
Model No.: LPV-200-24
Power Requirement(Input): AC 200-240V~50/60HZ
Power Requirement(Output): AC 24V
Power Consumption(Input): 226W
IP rating: IP67
Power Consumption(Output): 200W

Lithium cell
3V
0
2
2
R
5
C
QC8
Please note that Batter y Not Included
BATTERY SIZE: CR2025
FITTING OF BATTERY:
instruction below
1. Please depress the button to switch on / off.
2. The 2ndswitch located below the on/off switch will change the LED light colour by
depressing the colour button, each depress will activate the following sequence
1. Dark Blue
2. Green
3. Light Blue
4. Light Green
5. Purple
6. Red
7. White
QC8

Toolkit ListToolkit ListToolkit List
+ WASHER
+ WASHER

2980
2980
Upward View
Top View
ergola
3062
3062
Supremo

Pass through the power cord
Pass through the power cordPass through the power cordPass through the power cord
Post BC x 1

Area for the Power Control Box,
need to be fitted.
The washer is on
the right
In order to assemble correctly,please make sure A or C side of posts fit into corresponding A or C beam.

AB CD
AD
BC
Please do assemble the frame as per above graphic, or it will casue the length of LED
line on A/D beam is not enough to connect control unit.

AB CD
AD
BC
When installed correctly, all louvre
brackets will face same direction.

Tighten the screw

Middle Beam
Beam A
Beam C
Beam B
Beam D
The LED connected cables of beam A/B can
be hidden in L shape tube then connect
to 1042 Y shape connector in beam C
1042 Y shape connetor with RGB
control unit is placed next to control
box in L shape tube of beam C.
Control box has install
1041
1044
1042
set on Step One.
Power cord has been
on the Side Beam C

Blades assembly can be started from beam C to beam A one by one,
do not assemble it randomly.
It should be noted that need to install 1 and then 2
(As the picture)
41