mAUX: line input cable
nAUDIO OUTPUT: satellite output jack
oPower cord
Remote control
aEQ: equalizer mode selection button, active in the Player mode* only
b: next track (pressed short in the Player mode) and forward navi-
gation within a track (pressed long);
auto scan up the frequency range** (pressed short in the Tuner mode)
c: previous track (pressed short in the Player mode) and backward
navigation (pressed long);
auto scan down the frequency range*** (pressed short in the Tuner
mode)
dMODE: input selection button: Player*/Tuner/Line (pressed short);
e: Play/Pause (pressed long in the Player mode);
start/stop auto scan (pressed long in the Tuner mode);
Mute mode (pressed short in any mode)
f+/–: volume control buttons
g0-9: numeric buttons for entering a track number, frequency, preset station number
Note. Before operating the remote control, extract the battery, remove the Нlm protecting
the battery from discharge during transportation, and insert the battery back into the
remote control.
* If a device containing ԛles of the supported formats (USB Ԝash drive/SD card) isn’t connected,
the mode is inactive.
** The band is scanned if there are stations preset in the memory.
*** The storage device must be formatted as FAT, FAT32. Connecting devices other than USB Ԝash
drive is not recommended. Connection of HDDs and other devices can cause damage to the MSS.
5. PREPARATION AND OPERATION
Speaker placement
•Place the speakers symmetrically to the listener at least one meter away. The subwoofer emits
non-directional sound, therefore it can be located in any place of the room where it sounds the best.
•Place MSS far away from monitors and TV sets, as insigniԛcant image distortion in these super-
sensitive devices is possible.
Installation and operation
MS-300 speaker system can be connected to virtually any audio devices: DVD/CD players, PCs,
laptops, etc. (see connection diagram in Fig. 6).
• Before making any connections, make sure the MSS is oԚand unplugged. Then connect the sub-
woofer AUDIO OUTPUT jack nto the satellites with the built-in audio cable (see Fig. 6).
• To connect the MSS to a PC or ǀDŽ3/CD player, insert the line input cable mbuilt into the sub-
woofer into the LINE OUT port of your PC sound card or to the audio output jack of your ǀDŽ3/ CD
player, as shown in Fig. 6.
Fig. 5. Remote control
a d
e
f
c
b
g
ENG
4
2.1 Multimedia Speaker System
