i
j
k
AUDIO INPUT
5. PREPARATION AND OPERATION
Speaker placement
•Place the speakers symmetrically to the listener at the distance not
less than one meter, speakers can be wall-mounted.
•The subwoofer emits non-directional sound, therefore it can be
located in any place of the room, where it will sound to the best
advantage.
•Place MSS far away from monitors and TV sets, as insignificant
image distortion in these supersensitive devices is possible.
MSS сonnecting and control
MS-960 Multimedia Speaker System can be con-
nected to virtually any audio source: DVD/CD, PC
sound card, etc. (see connection diagram, Fig. 3).
•Before connecting make sure that the MSS is
switched off. Then, observing polarity (see Fig. 3),
connect the audio cables first to the jacks, and then
into SPEAKERS OUT L/R iof the subwoofer. The
positive (red) terminals of the active speaker must be
connected to the red terminals of the passive speaker
(+ →+), and the negative (black) terminals of the active
speaker must be connected to the black terminals of
the passive speaker (– →–).
•Connect the included 2RCA jacks of the signal cable
to AUDIO INPUT jL and R jacks of the subwoofer,
and insert the mini-jack (Ø 3.5 mm) of the signal cable
into LINE OUT port of the PC sound card or OUTPUT
of the DVD/CD/МР3-player. To connect the device to
OUTPUT of the DVD/CD/MP3-player or TV, use the
2RCA to mini-jack signal cable (included) + mini-jack
to 2RCA adapter (not included) or 2RCA to 2RCA
signal cable (not included).
Front and rear subwoofer panels
aVOLUME: master volume control knob
bTREBLE: TREBLE control knob
cBASS: BASS control knob
dBALANCE: BALANCE control knob
eSUB. VOL: subwoofer volume control knob
fEARPHONE OUT: headphone jack
gPOWER ON/OFF: POWER switch
hPOWER: POWER LED
iSPEAKERS OUT L/R: satellite outputs
jAUDIO INPUT L/R: audio source input
kPower cord
Fig. 1. Subwoofer
front panel
Fig. 2. Subwoofer rear panel
ON OFF
POWER
EARPHONEOUT
POWER
VOLUME
TREBLE
BASS
BALANCE
LR
SUB.VOL
a
b
c
d
e
f
g
h
ENG
3
Operation Manual MS-960
