Fig. 6
Fig. 7
Battery installation
• Open the cover of the battery box on the rear of
the manipulator.
• Install AAA type batteries into the battery box fol-
lowing their polarity. (included).
• Close the cover of the battery box.
Note:
• Always install a set of the same new bat-
teries. Incorrect installation of batteries may
damage the game controller!
• If the manipulator does not work, check the
battery or replace the discharged battery with
a new one.
• Remove the battery from the manipulator, if
you aren’t going to use it for a long time (more
than a week).
7. CONNECTION AND INSTALLATION
• After installation of batteries (Fig. 4 ), connect
2,4GHz Nano receiver via USB cable rto available
USB port of your PC. After connection to your PC,
device is automatically detected as a game
controller and is fully ready for use. However, for
Vibration Feedback function it is necessary to
install drivers. Calibration of second joystick is also
impossible without installation of drivers.
• Change POWER ON/OFF switch minto ON
position. For connection of Gamepad and Nano
receiver press FC button sof Nano receiver, the
connection indicator twill light up, then press FC
button eon the game controller. There is also
another way for connection of Gamepad and Nano
receiver: press FC button FC sof Nano receiver,
then press at the same time combination of
buttons «9+11» on the gamepad and hold these
buttons for 15 seconds. Attention should be paid
that Nano receiver and gamepad will be
disconnected, if a gamer presses one of «9+11»
buttons after connection has been made.
• Insert Software CD disk into your PC CD Rom
and start setup.exe for installation of drivers. For
testing and setting the game controller choose
Start →Control Panel →Game Controller. There will
open up Properties: PC TWIN SHOCK (Fig. 6) on
your desktop.
ENG
4
PC Wireless Gamepad
