SWELLPRO spry Use and care manual

SPRY Firmware Update Instruction V2.6
The Spry drone and the Spry remote controller can be updated by a firmware updater. 【But normally we
only update the drone firmware. 】
** Swellpro Firmware Tool only runs in Win7 & Win10 PC. Don’t support iOS.
** Got report some Win7 PC can’t run this FirmwareTool. If you have the same problem, try to
download a plugin and try: https://www.microsoft.com/en-US/download/confirmation.aspx?id=42642
** Shut down all the Anti-virus software and Remove the U disk from PC.
1. Download and unpack the file: SwellproFirmwareTool. zip. This is a compressed Windows folder,
which can be decompressed with programs such as WinZip, WinRar or 7zip.
2. Download the latest Spry firmware file “FW_FC_FF1_2019….bin” from swellpro. com.
3. From the unpacked Updater folder, run the file: SwellproFirmwareTool. exe
To update the Spry Drone firmware
4. Plug the Spry into the Windows PC using a good quality micro USB cable and wait for the Update
button to light up.
5. Click on “Firmware for Device 1” to select the drone firmware file (eg: FW_FC_FF1_2019….bin)
and then CLICK (1) on the right side, and then click Update.
6. Firmware update progress is displayed. Once completed, the Spry will reboot and sound a tone.

To update the Remote Control firmware
7. Plug the Spry Remote Controller into the Windows PC using a good quality micro USB cable
8. Power ON the Remote Controller.
9. Click on “Firmware for Device 2” to select the control firmware file (eg:
FW_RadioTX_FF1_2019...bin) and then CLICK (2) on the right side.
10. Click Update. Firmware update progress is displayed. Once completed, the Remote Controller will
reboot and sound a tone.
Following the firmware update, the drone will need to be recalibrated. Please follow the instructions in
the manual for Gyro calibration. Optionally, you can perform an IMU calibration, but only if you have a
level, stable location for IMU calibration.
How to check current Spry drone firmware:
1. Run the SwellproFirmwareTool.exe; 2. Turn on the drone and remote control; 3. Connect remote
control to computer with USB cable 4. Just a moment, click the FW Information button to get the
software version information as below:
“FM Version: 19021822” means current drone firmware, published in February 18, 2019, 22:00. The
firmware name just contains the date. | “FlightTime” means the all the flight time for the drone. | “ID”
means the unique number for the drone motherboard. | “HW” means the HW version. We only have one
hardware version.
Swellpro Tech: V2.6 - 2019.4.22