Swordfish VertiPoint User manual

VertiPoint Electric
Pencil Sharpener
Operating
Instructions

Please read the following instructions
before operating your sharpener.
Sharpening
The Swordsh VertiPoint sharpener is supplied
with a 9 Volt DC power adaptor. Plug the
adaptor into a convenient 13 Amp socket
and insert the jack-plug into the socket on
the rear of the sharpener.
Operating Instructions
●Insert a standard 8mm pencil into the
sharpener.
●The sharpener will start to operate. When
the pencil is sharp, the sharpener will stop,
automatically.
●To empty the sharpener, remove the top
cover and upturn the machine over a waste
bin.
●Please note that a safety interlock prevents
the sharpener from running when the top
cover is removed.
●Do not allow the shavings tray to over-ll
as this can cause permanent damage to
the sharpener mechanism.
Caution
●Adult supervision required.
●Do not insert a nger into the sharpener as
this may cause injury.
●This is a pencil sharpener. Do not insert any
other object.
●Do not immerse this sharpener in water.

Clean or replace the blade assembly
WARNING - the edges of the helical
blade are sharp!
●Remove the top cover.
●Loosen the three screws that secure the
blade support cage and remove it.

For troubleshooting and
product support, please visit
www.snopakebrands.com
●Insert the new blade.
●Replace the blade support cage. Note that
the raised rib at the top of the cage must
face forward.
●Replace the shavings tray cover before
using the sharpener.
●Lift out the old blade. Take care not to
lose the foam ring (A).
A