Synargy Smart Comfort Juno User manual

JUNO
MASSAGE CHAIR
QUICK START GUIDE &
OPERATING INSTRUCTIONS

QUICK START GUIDE
Remove your shoes and sit into the chair. You
can press down with your feet to extend the
footrest length. It is recommended to use the
massage chair without wearing jewellery or
watches.
Press the power button on the remote control,
and allow the chair 20-30 seconds to power on.
Place your arms inside the arm rests.
The chair will automatically enter an automatic
massage mode if no buttons are pressed.
You can enjoy this mode as it is, or read these
operating instructions to learn about more
advanced operation.

BASIC CONTROLS
• Power button turns the chair
on & o. Wait 20-30 seconds
for the chair to power on,
then select a mode on the
remote control. The chair will
automatically enter Comfort
auto mode if no options are
selected.
• Pause button stops the
massage rollers & functions,
until it is pressed again to
resume normal function.
• Times sets the massage
time in 5 minute increments
up 30 minutes.
• Shoulder position up &
down arrows adjust how far
up the shoulders the rollers
will travel during shoulder
focused movements.

AUTOMATIC MODE CONTROLS
Used for selecting the
following automatic massage
modes:
• Comfort is a gentle mode
that targets the whole body
• Relax focuses mainly on
lower back, legs & feet
• Full body focuses on the
entire body
• Neck & shoulder focuses on
the neck & shoulder areas
• Back & waist focuses on the
back & waist areas
• Stretch will lift the footrest
and tilt the chair back, while
focusing on the legs

CHAIR POSITION CONTROLS
Used for selecting the position
of the chair:
• button will bring the
chair back to upright
position. Press to return to
upright, or hold and release
to fine tune position.
• Zero button moves the chair
into zero gravity horizontal
position
• button will recline the
chair backwards. Press to
be taken all the way back, or
hold and release to fine tune
position.

MANUAL MODE &
ADJUSTMENT CONTROLS
Used for controlling the
following functions during
manual operation:
• Air pressure toggles airbag
function between: arms, feet,
arms + feet or o. (can also be
adjusted during automatic modes.)
• Intensity adjusts the
intensity of pressure from
the airbags (can also be adjusted
during automatic modes.)
• Mode changes manual
modes between the
following, or o:
kneading
shiatsu
tapping
kneading + tapping
knocking

MANUAL MODE &
ADJUSTMENT CONTROLS
• Speed adjusts the speed of the massage rollers during
manual modes
• Width adjusts the width between rollers during shiatsu,
tapping or knocking modes
• (back mode) toggles back massage modes between:
H0 fixed position back massage
H1 short area back massage
H2 entire back massage
H3 upper back massage
H4 lower back massage
• The arrows either side of back mode will adjust the position
of rollers during H0 and H1 back modes
• Foot roller button switches the foot roller on & o*
• Roller intensity button switches the foot roller between 3
speed settings*
*can also be adjusted during automatic modes.

JUNO MASSAGE CHAIR
Health and Safety Warnings: Do not drop or push anything into any slot of the machine.
Please stop immediately and consult your doctor if you feel unwell when using this machine.
Not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless supervised. Do not use if
you are pregnant, unwell, or have a pre-existing medical condition. Do not sit on the back,
armrest, or the leg rest as it may result in damage or injury. Do not press or put your hands
into the cloth cover of the massage hands.
Keep at least 275mm of clear space between the chair backrest and nearby walls or furni-
ture to ensure there is no contact with any items when chair is fully reclined.