Tailfin AeroPack User manual

AeroPack
Assembly Instructions
www.tailfin.cc
[e-mail]
for further assistance
Torx T25 Wrench
&
Torque Wrench
20 minutes

AeroPack
What’s included
1
2
3
4
AP20 Top Bag
Connector Parts
Arch
1
5
Fast Release Dropouts*
Axle*
1
2
4
3
5
* For ‘Axle + Fast Release Dropout’ option
If Direct Mounting click here

Orientate Arch and Fast
Release Dropouts
Step One
A
B
C
Use the Tailfin logo to
orientate the Arch.
Place Dropout on Arch.
The sloped side of the
dropout faces outside
The quick release pin
faces backwards
A
CD
*Not applicable to Direct Mount setup, proceed to Step 3
D
The logo is legible when
stood behind the bike. This
will ensure panniers are
also at the correct angle
B

Attach Fast Release
Dropouts
Step Two
AAttach Dropouts to the
Arch using the
countersunk screws
included.
Tighten screws in turn to
5Nm
A

Attach Connector Parts (i)
Step Three
A
C
Install first Connector piece
by pushing in place
Install small Connector
piece to Arch
Rotate both parts together
Screw together using
shorter M5*10mm screw.
Tighten to 5Nm
B
D
AB
CD
B