Taiyi Tech YT190428A User manual

Chargeupp Wireless Charger Instruction Manual
Safety Instructions
Read and follow all safety instructions.
1.Applicable operation temperature range is from 0℃to 30℃and can be stored at ambient
temperature between 0℃to 50℃with ambient humidity less than or equal to 90%. Pad or battery of
the charging mobile device may be damaged if Pad is not being used properly.
2. Avoid Pad receiving violent impact or intentional pressing, exposing to the sun and rain, or getting
contact with corrosive substances. Keep away from fire.
3.Use Pad with certified adapter ONLY or those applied to international standard rules (5V/2.5A, 9V/2A,
12V 1.5A).
4.Do not disassemble, modify or repair Pad yourself. Contact your distributor for after sale service if
there's any questions.
5. Avoid children and pets chewing or swallowing Pad.
6. Recycle Pad properly for environmental protection.
Hazardous substance test result:
Mercury / Cadmium / Chromium 6 / PB / PBDEs (O)
O: Content of the hazardous substances in all homogenous materials of the part is below the prescribed
limits in accordance with GB/T26572 standard.
Lead (X)
X: Content of the hazardous substances in a homogeneous material of the part is exceeding the
prescribed limits in accordance with GB/T26572 standard.
Parts
A. Wireless charger surface
B. Wireless charger plug-in
C. Indicator light
User Guide
1. Plug in USB to power with certified adapter (QC 2.0 adapter is required).
Model: YT190428A

2. Place mobile device (with wireless receiver built-in or attached) onto Pad's surface evenly and
properly.
3. Remove mobile device from Pad's surface when it is fully charged.
Indicator light description
1. Indicator light will be on for about 4 seconds for self-testing after connecting with power.
2. Indicator light flashes every 3 seconds at standby mode.
3. Indicator light will always be on at charging mode.
4. Flashing indicator light on shows output voltage is too low to charge. Change to stronger power
and/or use QC 2.0 or QC 3.0 adapter.
5. Fast flashing indicator light on or light off shows charger and mobile device are not stably connected.
Readjust the connection and make sure there is no metal placed between charger and receiver.
Troubleshooting
1. Pad is not working.
Check and make sure Pad's USB plug-in is well connected to proper power and/or adapter.
2. Mobile device is power off during charging or not being fully charged.
Check and make sure the adapter is a certified product or those applied only to international standard
rules.
One Year Warranty
Shenzhen Qitian Taiyi Technology Company Limited (hereinafter referred to "Company") warrants this
product (see Exclusions below) to the original purchaser against defective material and workmanship
that occurs during normal use for one year. Company will, at Company's option, either repair or replace
same without charge (but no cash refunds will be made).
1. Damage resulting from accident, misuse, abuse, lack of reasonable care, subjecting the product to any
but the specified electrical service, other than normal and ordinary use of the product, subjecting the
product to abnormal working conditions or any other failure not resulting from defects in materials or
workmanship.
2. Damage resulting from modification, tampering with or attempted repair by anyone other than the
Company or designated repair representative by the Company.
3. Transfer of product to someone other than the original consumer purchaser.
4. The warranty is not valid for components subject to wear and/or to counterfeits.

FCC ID: 2ATOD-YT190428A
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for aClass B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, ifnot installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in aparticular installation.
If this equipment doescause harmful interference to radio or television reception,
which can be determined by turning the equipment offand on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator &your body.This transmitter must
not be co-located or operating in conjunction with any other antenna or transmitter.