Tanco 1540 EH User manual

TRACTOR CONNECTION
1. Hydraulics
Red pipe > Supply (30-35lpm)
Blue pipe > Return (Free flow return!!)
2. Electrics
A. Connect 12V supply to 3pin plug
B. Connect wrapper harness to controller
ENTERING THE WORKING POSITION
1. Remove the wrap arm transport lock.
2. Position the safety arms into the working
position by removing the retaining pin.
3. Adjust the roller arm stops. This is done by
adjusting the position of the pin. This should
be done for different size bales.
4. Install the roll of film and attach the film to
the Cut & Start.
B
A
4
1
2
3
1540 EH QUICK REFERENCE GUIDE
The quick reference guide is not a substitute for the Operators Manual!
Please refer to Operators Manual for more detailed information

OPERATION
1. “A” on the center of the display
indicates that the controller is set in
Automatic mode.
2. With the rollers in the open position,
bring the machine into the bale.
3. Press “Rollers in” (a) to load the bale.
4. Press “Auto start” (b) to begin the
wrapping cycle.
I. The wrap arm will first unfold to the
straight position.
II. It will then complete the target number of
wraps.
III. On the last half revolution the wrap arms
will return to the folded position, and
then come to a stop after bringing the
film into the cutter.
IV. The wrap arms will then reverse to the
center.
5. Press “Rollers out” (c) to unload the
bale.
6. To manually interrupt the wrapping
cycle, press the “Pause” (d) button
which will bring wrapping to a
controlled stop.
7. Press “Resume” (e) to continue the
Auto-wrap cycle from where it
stopped.
Note: “Rollers in” & “Rollers out”
functions can be operated by “one touch”
meaning that the operator does not need
to keep the button pressed. To activate
“one touch” increase “Rollers in” &
“Rollers out” time in the Operator Menu.
a
c
d
Auto mode (A)
e
a
b

EXPERT CONTROLLER OPERATION
OPTIONAL RF REMOTE OPERATION
The RF (Radio Frequency) remote is required if you wish to operate the 1540EH
wrapper statically.
Auto Start wrap
Close Cut & Start
Load the bale
Emergency Stop
Rotate wrap arms
in reverse
Rotate wrap
arms forward
Offload the bale
Open Cut & Start
RF Receiver
The red button on the
rear of the remote must
be pressed while
pressing any other
button (except “STOP”).
- Current No. of wraps
- Target No. of wraps
- Wrapping speed (RPM)
- Bale total
- Grand total No. of bales
- Mode: Manual /Auto
Pause wrapping
Open cutter
Fast wrap arm rotate /
Resume wrapping
Pause bale rotation
(during wrapping)
Rollers in
Start Auto wrap cycle
Select Manual or Auto
4-way Menu switch:
- Set no. Of wraps
- Change/Reset Bale Sub-Total
- Access Operator Setup Menu
- Access Technician Setup Menu
- Access Manual Wrap Arm Fold
(second function on L5/R5)
Add extra wrap
Close cutter
Slow wrap arm rotate
Reverse wrap arm
Rollers out
Power on/off /
Emergency Stop

ENTERING THE TRANSPORT POSITION
1. Fully close the loading rollers.
2. Rotate the wrap arm until it is behind
the Cut & Start.
3. Insert the wrap arm transport lock.
4. Lock the safety arm into the transport
position.
4
3