Teledyne 3000MA User manual

Addendum for Model 3000MA Percent Oxygen Analyzer
Page 1
Teledyne Analytical Systems
Q002870 C.O. 85723
The instruction manual included with your analysis system from
Teledyne Analytical Instruments describes the standard features of
the system. Refer to the manual for information regarding all
standard features of the model that you have selected.
In addition, your specific system has been designed according to the
needs that you specified at the time of purchase. The information
contained in this addendum addresses those needs and supersedes
any conflicting instructions and descriptions in the standard
instruction manual.
NOTE: All drawings that relate to your system are at the rear of
this manual.
System Overview
The Model 3000MA Percent Oxygen Analyzer is configured with a
Paramagnetic sensor and auto cal valves. This instrument has a
general purpose area class.
Power Requirements
This instrument operates from a power source of 220 VAC at 50/60
Hz.
Analysis Range
The Model 3000MA has three user defined analysis ranges of 0-5 to
0-100 Percent Oxygen (O2).
Signal Outputs
This Model 3000MA has a signal output of 4-20mA isolated.
Additional Operating
instructions and/or
information for your
Model 3000MA
Percent Oxygen
Analyzer

Addendum for Model 3000MA Percent Oxygen Analyzer
Page 2
Teledyne Analytical Systems
Software
The software for this instrument adds hold timers for span and zero
calibration; each calibration has its own timer separate timer.
Span Delay:
By pressing the Span key, the operator accesses the setup mode of
the span calibration. After selecting AUTO span calibration the
following screen will be the hold timer adjustment:
Span Delay: 5 min.
<ENT> For Next
The hold time for the span can be adjusted between 1 minute and 60
minutes. Five minutes is the factory default. When changed the value
is stored so it can be recovered after power down.
Zero Delay:
By pressing the Zero key, the operator accesses the setup mode of
the zero calibration. After selecting AUTO zero calibration the
following screen will be the hold timer adjustment:
Zero Delay: 5 min.
<ENT> For Next
The hold time for the span can be adjusted between 1 minute and 60
minutes. Five minutes is the factory default. When changed the value
is stored so it can be recovered after power down.
Reference Drawings
D74505 Outline Diagram
B74504 Piping Diagram
Spare Parts
A78648 EPROM Software Assembly
Project Engineer ________________ Date ______________