Tennant T290 User manual

This guide is intended for quick consultation only and does not replace the user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the
instructions.
PREPARATION & OPERATION
T290 (Push Model)
Quick Guide
ATTACHING/REMOVING THE BRUSHES
$WWDFKLQJWKHEUXVKUHVWWKHEUXVKRQWKHÀRRULQIURQWRIWKHPDFKLQHDQGFHQWUHLWZLWKWKHJXDUG/RZHUWKHKHDG
DQGRSHUDWHWKHEUXVKGULYHOHYHUUHSHDWHGO\XQWLOWKHEUXVKDXWRPDWLFDOO\HQJDJHVRQWKHÀDQJHKXE,IWKHRSHUDWLRQ
is not successful, repeat by pressing on the lever again and repeating the centring.
Removing the brush: raise the machine head by pushing the head lift pedal down and then to the right and operate
the brush/drive lever repeatedly. After operating the lever a few times, the brush is released and falls to the ground.
1
5
23
64
3/'& EN
HO
2
ON
CHEM
HO+
HO
2

5(3/$&,1*7+(648((*((%/$'(6
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
5HXVHWKHVDPHEODGHE\UHYHUVLQJWKHHGJHLQFRQWDFWZLWKWKHÀRRUXQWLODOOIRXUHGJHVDUHZRUQRXWRUUHSODFHZLWKDQHZEODGH¿WWLQJLWRQWRWKH
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
'$,/<0$,17(1$1&(
Clean the dirty
water tank. &KHFNWKHVXFWLRQ¿OWHULV undamaged and clean.
Check that the
GHWHUJHQWRXWOHW¿OWHU
is clean.
Check that the brush
is clean. Replace if
necessary.
Check that the
squeegee is clean
and the blades are not
worn.
3/'& EN
1
2
BATTERY CHARGER ON BOARD