Therian Kuranda Bunk Bed User manual

3. On bottom bed fabric, Secure two bottom
corners (as oriented in the picture below) with
pan head screws and lock nuts. You can
insert the bunk post into the corner as well.
4. Tighten bolts, be careful not to over tighten.
1. Lay fabric flat with underside facing up and
insert cording into sleeves.
NOTE: Heat welded fabrics have the cording
already encased in outer edge of fabric.
2. Insert fabric into the channel on each length of
pipe.
Tools Needed –Phillips Head Screwdriver, 7/16 Wrench or Adjustable Wrench
Flat surface to work on (table preferred)
Parts List-
2 Fabric Mats
8 PVC or Alum slotted pipe (4 long / 4 short)
4 bunk legs
4 PVC or Alum crate legs –4 leg caps
4 top corners –8 bottom corners
8 machine screws, 8 pan head screws (2 ¾”), 16 lock nuts
8 pieces white plastic cording (shipped inside bed frame Ballistic & Vinyl Weave fabrics)
(Note: there may be extra parts so the beds can be used individually or as a bunk bed.)
5. Check top corners to be sure they are square.
Set top fabric with pipe sleeves on top of upper
corners. Screw top corners into place using
machine screws and locknuts.
12
3 4
5
Assembly Instructions For Kuranda Bunk Beds
6. Place rubber caps on crate legs and insert legs into
corners.

KURANDA DOG BED GUARANTEES
HOW ARE THE DOG BEDS CHEWPROOF?
Any place the fabric is in aposition to be chewed, it is protected by apoly-resin sleeve.There are no corner
gaps to bite.Once in awhile adog will bite through aleg or side piece but it is quite rare.This image shows
how the fabric fits into the frame of the bed so your dog cannot reach the fabric.Caution:Fabrics are
vulnerable to tearing by persistently scratching or digging dogs.
KURANDA DOG BEDS ARE GUARANTEED CHEWPROOF FOR ONE FULL YEAR!
Kuranda guarantees the structural integrity of the frames and fabrics of their dog beds against chewing by a
dog for aperiod of one year from date of purchase.Accordingly, Kuranda will replace frame parts and fabric
damaged by dogs chewing the bed only to the point of not being useable at no charge during this period.This
warranty excludes damage caused by dogs scratching the fabric.This warranty includes chewing of corner
fittings and legs.Fabrics covered under this guarantee by chewing only are 40 oz solid vinyl and Ballistic nylon.
Multiple fabric replacements for the same bed will be handled on acase by case basis.
Please call us if you have any questions in Australia on 1800-251-766
NOTE: TIGHTEN PROPERLY –correct tightening
will leave end of bolt flush with the nuts’ white nylon
locking material.
INSUFFICIENT OR OVER TIGHTENING OF THE
CORNERS MAY RESULT IN CRACKING.
Unit 4, 26 Commercial Drive,
Ashmore QLD 4214
Tel: [phone]
Fax: [phone]
www.therian.com.au
Assembly Instructions For Kuranda Bunk Beds
Product Advisory (PVC corners)
Please be aware that we have found that over tightening the screws on the corners of the beds (even by just
one or two full threads) can cause enough added stress that the corner pieces may fail. To maximize the life
of the corner fittings, the screw should be flush with or slightly inside the nylon locking material in the nut. If you
have any questions, please feel free to contact us by return email, or our toll free phone number. 1800-251-
766.
Figure 1.
Correctly tightened. Screw is
flush with nylon locking material.
Figure 2.
Incorrect -too tight. Screw
extends beyond edge of nut.