Titan TTB155STM Installation manual

Warning: Read all safety warnings and all instructions. Failure to follow all
instructions listed below may result in serious injury. This product should
Never be left unattended when connected to the mains supply.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
The plug must be removed from the socket-outlet before cleaning or maintaining the
appliance.
ELECTRICAL SAFETY
Before switching the product on, make sure that the voltage of your electricity supply is the
same as that indicated on the rating plate.This product is designed to operate on 230V AC 50Hz.
Connecting it to any other power source may cause damage.
ADDITIONAL SAFETY WARNINGS

PLUG REPLACEMENT
If you need to replace the fitted plug then follow
the instructions below.
IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
Green & yellow ---Earth
Blue ---Neutral
Brown ---Live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows. The wire which is
coloured green & yellow must be connected to
the terminal which is marked with E or .
The wire which is coloured blue must be
connected to the terminal which is marked
with N. The wire, which is coloured brown,
must be connected to the terminal, which is
marked with the letter L.
WARNING: Never connect live or netutral
wires to the earth terminal of the plug. Only fit
an approved 13 Amp BS1363/A plug and the
correct rated fuse.
Note: If a moulded plug is fitted and has to be
removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
If the supply cord is damaged it must be
replaced by a service agent or a similarly
qualified person in order to avoid hazard.

Authorised Signatory and technical file holder
Date: 01/01/10
Signature:
Name: Peter Harries
Titan PowerTools (UK)Ltd.Trade House , Mead Avenue ,BA22 8RT
Quality Manager 2010