TKE S100 User manual
TK Home Solutions B.V. User’s manual S100 Call module
Reference: 012 –1122596 Call module user manual partially page 2 of 6
Version: A.1
State: Unreleased
TABLE OF CONTENTS
1Introduction ........................................................................................................ 4
1.1 Making a call ........................................................................................................... 4
1.2 Disconnecting.......................................................................................................... 5
1.3 Choosing the next number ...................................................................................... 5
1.4 Accepting incoming calls ......................................................................................... 6
1.5 Error codes ............................................................................................................. 6
TK Home Solutions B.V. User’s manual S100 Call module
Reference: 012 –1122596 Call module user manual partially page 3 of 6
Version: A.1
State: Unreleased
FCC and IC Declarations
Compliance statement Canada & FCC (part 15.19)
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s) and complies with part
15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation of the device.
Warning (part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Information to the User (Part 15.105 (b))
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Complies with: CAN ICES-3 (B)/NMB-3(B)
TK Home Solutions B.V. User’s manual S100 Call module
Reference: 012 –1122596 Call module user manual partially page 4 of 6
Version: A.1
State: Unreleased
1 Introduction
This manual has been derived from the user manual of the S100 stairlift. This
document describes the use of the Call module as mounted in a S100 stairlift1. The
Call module (CM) is an optional function of a stairlift. This option makes it possible to
communicate via a landline with up to three pre-programmed telephone numbers, for
example in case of an emergency. Incoming calls can also be accepted.
1.1 Making a call
1. Press the yellow alarm button for 4 to 7 seconds. The dialling tone can now
be heard.
2. Release the alarm button. The light on the alarm button has now turned green.
3. If the contact answers, you can communicate by speaking in the direction of the
alarm button.
1Note the Call module is identified with Manufacturing part number M/N 1122596 and a complete
stairlift with S100.
TK Home Solutions B.V. User’s manual S100 Call module
Reference: 012 –1122596 Call module user manual partially page 5 of 6
Version: A.1
State: Unreleased
1.2 Disconnecting
1. Press the yellow alarm button for 4 to 7 seconds. The light on the alarm button
turns off.
The call has now ended. It is also possible for the person being called to hang up.
1.3 Choosing the next number
If the connection to the first contact fails, you can choose to go to the next pre-
programmed number. This is done as follows:
1. During the call, press the yellow alarm button once briefly. The next number will
now be dialled.
NOTE
If the contact’s number redirects to voice mail, you must also briefly press
the yellow alarm button once to call the next number.
TK Home Solutions B.V. User’s manual S100 Call module
Reference: 012 –1122596 Call module user manual partially page 6 of 6
Version: A.1
State: Unreleased
1.4 Accepting incoming calls
The landline is connected to the Call module. An incoming call can therefore
also be accepted while using the stairlift.
When there is an incoming call, the Call module produces a ring tone.
Accepting the call is done as follows:
1. Briefly press the yellow alarm button once. The connection is now established.
Speak in the direction of the alarm button to communicate. The call can be
ended by pressing the yellow alarm button for 1 second.
1.5 Error codes CM
LED colour
Sound
Cause
Off
None
Standby mode
Flashing red
None
Module is not registered to
a base station
Flashing red
Single beep every 20
seconds
Module cannot find the
base station it is registered
to (either because it is out
of range or because the
base station has been
disconnected)
Constant green
Dialling tone
Trying to establish a call
Flashing green
Busy tone
The far-end caller has
disconnected the call
Constant green (after
initiating a call attempt)
None
There is no telephone line
connected to the base
station
For other questions, please contact your supplier.
Table of contents
Other TKE Stairlift manuals
