TKH security FD950 User manual

© TKH Security B.V.
FD950
5MP Vandal Fixed Dome Camera
Quick Start Guide
Unpack Installation Notices Connectors
Connector Definition Camera Cabling Alarm I/O and RS-485 Connection
Find additional manuals, the
datasheet, the EU Declaration of
Conformity, and the latest firmware
for this product at:
tkhsecurity.com
CAUTION INSTALLATION SHALL BE PERFORMED BY
QUALIFIED PERSONNEL ONLY. INSTALLATION SHALL BE IN
ACCORDANCE WITH LOCAL PROCEDURES. THE CAMERA
CONTAINS BATTERIES. DO NOT REPLACE IN RISK OF
EXPLOSION.
BATTERY REPLACEMENT SHALL NOT BE APPLIED IN VIEW
OF THE RISK OF EXPLOSION. LE REMPLACEMENT DES
PILES NE DOIT PAS ÊTRE APPLIQUÉ AU RISQUE
D'EXPLOSION. DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS. METTRE AU REBUT LES
BATTERIES USAGÉES CONFORMÉMENT AUX
INSTRUCTIONS..
FOR “PoE” INPUT CONNECTION, USE ONLY WITH UL
LISTED I.T.E WITH “PoE” OUTPUT. DESCRIPTION FOR THE
“PoE” IS INTENDED TO BE CONNECTED TO NOT EXPOSED
(OUTSIDE PLANT) NETWORKS OR EQUIVALENT
STATEMENT IN INSTALLAION INSTRUCTIONS.
POUR LA CONNEXION DâÇÖENTREE "PoE", UTILISER
UNIQUEMENT AVEC UN I.T.E. LISTE AVEC UNE SORTIE
"PoE". LA DESCRIPTION DE "POE" EST CONÇUE POUR
ÊTRE CONNECTÉE À DES RÉSEAUX OR NON ÉNONCÉS
(INSTALLATIONS EXTÉRIEURES), DANS LES
INSTRUCTIONS D’INSTALLATION DE L’INSTALLATION.
Subject to modification. Actual product and accessories may differ in appearance.
FD950
IT IS NOT RECOMMENDED TO CONTINUOUSLY
(24/7) RECORD WITH THE MICRO SD CARD, AS
THE CAMERA MAY NOT SUPPORT LONG-TERM
CONTINOUS DATA READ/WRITE. CONTACT THE
MANUFACTURER OF THE MICRO SD CARD FOR
INFORMATION REGARDING THE RELIABILITY
AND THE LIFE EXPECTANCY.
Figure 1 Camera Connectors
See the diagram and the pin definition below for the
audio and alarm I/O connection.
Figure 2 Diagram of I/O connection pins
Pin
Definition
Pin
Definition
1 Audio In L 6 Alarm Out +
2 Audio In R 7 Alarm Out -
3 GND 8 Alarm In +
4
Audio Out L
9 Alarm In -
5
Audio Out R
Table 3 Pin definitions for Alarm I/O and RS-485 connection
Table 1 Connector definition
❑The green link LED is lit when there is a good network
connection.
❑The orange network LED flashes to indicate that there
is network activity.
IN SOME CASES, AN ETHERNET CROSSOVER
CABLE MAY BE NEEDED WHEN CONNECTING
THE CAMERA DIRECTLY TO THE PC. CHECK THE
STATUS OF THE LINK INDICATOR AND THE
ACTIVITY INDICATOR LEDS. IF THE LEDS ARE
UNLIT, CHECK THE LAN CONNECTION.
Power Connector (DC 12V/AC24V)
Table 2 Pin definition for power connection
Pin Definition
1 AC24V +
2 AC24V -
3 DC12V +
4 DC12V -
Quick Start Guide
Plastic Screw
Anchor(x2)
4-pin power terminal
block
DC 12V Power
Connector
M4 Self-tapping
screw(x2)
Cable Gland
Security Torx
BNC Connector
No.
Connector Definition
1
RJ
-45 Port
(Contact Siqura for a
compatible PoE
injecter.)
For network and PoE connections
2
BNC
For analogue video output
3
Power(DC 12V/AC
24V)
Power Connection
4
Reset Button
Press the button with a proper tool for at
least 20 seconds to restore the system.
5
Micro SD
Card Slot
Insert the SD card into the card slot to store
videos and snapshots. Do not remove the
SD card when the camera is powered on.
6
Alarm & Audio I/O
Alarm I/O & Audio connection
+ 1
- 2
+ 3
- 4
123456789
2021 | Vision 1 (20210531) | FD950 QSG

© TKH Security B.V.
1st time camera login
Browser-based Viewer
Figure 4 shows the main page of the IP camera user interface.
Accessing the Camera
Install browser-based viewer
IP = 10.1.1.1
Netmask: 255.0.0.0
Auto detect with SDM2
Install browser-based viewer
Tkhsecurity.com
Enter to the camera
product page, Link &
Download section
If the web interface is not showing video, you might to open your
firewall or set the OCX protocol to RTP-over-RTSP(TCP)
IP = 10.x.y.z
Network Switch
DHCP
1
2 3
SDM2-vx.xx-setup.zip
Look for SDM2
1
Admin
Admin1234
2Set strong password
qwer1234
x6W@oM0a!9#F
3
x6W@oM0a!9#F
4
11 Note 1: If the IE web interface is not showing video, you might
need to open your firewall or set the OCX protocol to RTP-over-
RTSP(TCP).
Figure 4 Main page IP camera user interface
2021 | Vision 1 (20210531) | FD950 QSG