TKH security SIQURA XCU3 Series User manual

DOWNLOAD THE INSTALLATION MANUAL FROM TKHSECURITY.COM
AND FOLLOW ITS INSTRUCTIONS.
CAUTION:
INSTALLATION SHALL BE PERFORMED BY QUALIFIED PERSONNEL ONLY.
INSTALLATION SHALL BE IN ACCCORDANCE WITH LOCAL PROCEDURES.
DO NOT EXPOSE THE CONNECTORS TO EXCESSIVE HEAT OR PHYSICAL
SHOCK.
IF YOU USE AN EXTERNAL POWER SUPPLY, CONTACT TKH SECURITY TO
MAKE SURE THAT THE POWER SUPPLY HAS THE PROPER POWER
SPECIFICATIONS.
MAKE SURE THAT THE POWER SUPPLY COMPLIES WITH LPS
REQUIREMENTS.
WHEN INSTALLING THE CAMERA, MAKE SURE TO USE THE PROPER XCU
BRACKETS AND ACCESSORIES.
FOR MORE INFORMATION, CONTACT TKH SECURITY.
Unpack
Mounting the camera on a bracket
Camera Mounting Brackets
Camera Power Cable
XCU3-Compact
316L 2MP AI-prepared compact camera, h.264/h.265
Quick Start Guide
Find the installation manual, the
datasheet, the EU Declaration of
Conformity, and the latest firmware for
this product at:
TKHsecurity.com
Quick Start Guide
XCUCNC-PWR01
IP67 Power cable connector
XCUCNC-RJ45 /-2SM /-2MM
IP67 Ethernet or fiber cable connector
Note 1: Subject to modification. Actual product and accessories may differ in appearance.
© TKH Security 2023
Vision 0.1 (2020607)
XCU3_C_QSG
RJ45 Ethernet Cable
Installation Notices
XCU-compact
Use the appropriate mounting brackets for the XCU Compact
XCUWM01 Wall/Pole
mount bracket
XCUCM01 or CM02 Ceiling
mount bracket
XCUSW01 Swivel
mount bracket
XCUFP01
Fall protection cable
2
1
4
1. Place the camera with the 4 bolts and washers through the four
slots of the bracket.
2. Slide the camera forward, as far as it will go
3. Install the bolts to secure the camera to the bracket
4. Connect the fall protection cable to both the camera and the
bracket
3
1
XCUCNC-PWR01:
- Cable diameter: 6-12mm.
- Screw termination: Wire range 0.5 –1.5 mm2
(L) 230 Vac
(+) 24 VDC/VAC
(N) 230 Vac
(-) 24 VDC/VAC
XCUCNC-RJ45:
- Cable diameter: 4-8mm.
- Wire size AWG24
- Shielded CAT6A

Accessing the Camera Auto Detect with Device Manager SDM2
IP = 10.1.1.1
Netmask: 255.0.0.0
IP = 10.x.y.z
(PoE) Network Switch
No DHCP
Download SDM2
SDM2-setup.exe
2
3
1Install SDM2
Run SDM2 and double click the camera
1st Time Camera Login
2
Enter an admin username and strong password. Click “Next”.
qwer1234
x6W@oM0a!9#F
1
10.7.147.117
Click “Activate” to save the initial admin user.
IP = 10.1.1.1
Netmask: 255.0.0.0