TKH security BL2005v2M User manual

©TKH Security B.V.
BL2005v2M
5MP Vandal Bullet Camera
Quick Start Guide
Unpack Installation Notices Connectors
Connector Definition Camera Cabling Waterproof Notice
Find additional manuals, the
datasheet, the EU Declaration of
Conformity, and the latest firmware
for this product at:
tkhsecurity.com
Caution installation shall be performed by qualified
personnel only. Installation shall be in accordance
with local procedures. The camera contains batteries.
Battery replacement shall not be applied in view of
the risk of explosion. Dispose of used batteries
according to the instructions.
For "PoE" input connection, use only with UL listed
I.T.E. with "PoE" output. Description for the "PoE" is
intended to be connected to not exposed (outside
plant) networks or equivalent statement in installation
instructions.
Subject to modification. Actual product and accessories may differ in appearance.
Figure 1 Camera Connectors
Table 1 Connector definition
No. Connector Definition
1Alarm I/O Alarm I/O connection
2Audio I/O Line In and Line Out connection
3RJ-45 Port
For network and PoE connections. Please
contact TKH Security for a compatible PoE
injector.
4Power (DC 12V) Power Connection
5Micro-SD Card Slot
Insert the SD card into the card slot to store
videos and snapshots. Do not remove the SD
card when the camera is powered on.
6Reset Button Press the button with a proper tool for at least
20 seconds to restore the system.
2021-2022 | Version 2 (20221223) | BL2005v2M QSG
Figure 2 Cabling
Quick Start Guide
Security Torx
Screws(4x) &
Plastic Screw
Anchors (4x)
Mounting Adapter
Camera Unit
CAT-6 RJ45 conduit
& Pin pusher 1234
Figure 3 Wall/Pole Mount
Figure 4 Ceiling Mount
Bullet camera is suggested to be mounted either by
wall/pole mount or ceiling mount.Other mounting may
cause potential water leakage at camera, which is not
covered in warranty.
56

©TKH Security B.V.
Auto detect with SDM2
Browser-based Viewer
Accessing the Camera - DHCP
1st time camera login
Accessing the camera –Fixed IP
1st time camera login
Tkhsecurity.com
Enter to the camera
product page, Link &
Download section
IP = 10.x.y.z
Network Switch
DHCP
1
2 3
SDM2-vx.xx-setup.zip
Look for SDM2
x6W@oM0a!9#F
11
Set a strong password
qwer1234
x6W@oM0a!9#F
IP = 192.168.1.x
IP = 192.168.1.x
Network Switch
DHCP
30s
DHCP
IP = 10.x.y.z
2021-2022 | Version 2 (20221223) | BL2005v2M QSG
It is not recommended to continuously (24/7) record
with the micro-SD card, as the camera may not
support long-term continuous data read/write. Contact
the manufacturer of the micro-SD card for information
regarding the reliability and the life expectancy.