3
www.topvehicletech.com
FITTING GUIDE
STEREO REMOVAL
FASCIA PLATE SET-UP
DASH MODIFICATION
Some plascs will need to be cut and removed from the dashboard to make space for the new car stereo.
Measure where the stereo will sit and take due care when modifying the vehicle. TopVehicleTech always promote the
help of professional installers. TopVehicleTech will not be held responsible for any damage to the vehicle.
1. Use a bojo tool to pry away and unclip the middle trim panel above the main radio.
2. Using the bojo tool again, pry away the plasc panel holding the air controls & buon panel. Once out,
proceed to disconnect any/all wiring from behind.
3. With the air control panel removed, it will reveal 2x screws that will need to be undone to free the main
radio. Once free, pull out of the dashboard and disconnect all the wiring.
1. Take the OEM air con panel and begin to unclip the manual air con unit, this can go directly into the new
fascia.
2. Undo the 5x screws that surround the back casing of the buon panel and remove the PCB board. Once
out, gently disconnect the white connector. Re-connect the white connector found on the replacement
ribbon extension cable which comes with the kit.
3. Proceed to mount the PCB with buon front/back to the new fascia panel. Connect the black connector
on the lead to the air condioning panel and route the wiring neatly to the side.
5. When happy with the alignment, and the “Stereo Installaon” process is complete, screw the stereo
into the dashboard using the pre-exisng screws. Then simply install the fascia on top.
4. Aach the brackets to the new stereo using the screws within the kit. With the brackets aached, oer
the whole unit to the back of the fascia and test t within the vehicle to gauge the correct depth.
