20
7.6 Error messages/trouble shooting
Display Cause What to do
E02 Stator over-temperature
(motor overheating)
Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E05 Motor/propeller blocked Disconnect motor cable from battery, then loosen blockage
and turn propeller one revolution by hand. Reconnect
motor cable.
E06 Voltage in the motor too
low
Low battery charging status. Motor can potentially be used
again slowly from the stop position.
E07 Motor overcurrent Continue at low output.
E08 Circuit board overheating Motor can be used again after a short wait about 10 mi-
nutes). Contact Torqeedo Service.
E21 Tiller calibration defective •Re-calibrate:Press“cal”buttonfor10seconds.
•Thedisplayshows“calup”:Presstillerforwardtofull
gas then press the “cal” button.
•Thedisplayshows“calstp”:Returntillertocentralposi-
tion then press the “cal” button.
•Thedisplayshows“caldn”:Presstillerbackwardtofull
gas then press the “cal” button.
E22 Magnetic sensor defective Re-calibrate (refer to E21)
E23 Value range false Re-calibrate (refer to E21)
E30 Motor communication
error
Checkthemotorcable’splug-inconnection.Checkthe
motor cable for damage.
E32 Tiller communication error Check the tiller‘s plug-in connections. Check the cable.
E33 General communication
error
Check the plug-in connections and cables. Switch the
motor off and on again.
E41, E42 Incorrect charging voltage Use a Torqeedo power supply. If the error occurs in spite
of using a Torqeedo power supply, wait untill the battery
dissipates the overcharge. Should the error persist please
contact Torqeedo Service.
E43 Battery empty Charge battery. Motor can potentially be used again slowly
from the stop position.
E45 Battery overcurrent Switch motor off and on again. If this error occurs the
battery status indicator and range display can no longer
operate until the battery has been fully charged again.
E46 Battery operating tempe-
rature error
Batterycellsoutsideoperatingtemperaturebetween-20°C
and+60°C(-4°Fto140°F).Themotorcanbeusedagain
whenthetemperaturehasstabilized.
E 48 Charging temperature
error
Charging will continue when the cell temperature is
between0°Cand+45°C(32°Fto113°F).
Other error
codes
Faulty Contact Torqeedo Service and notify them of the error
code.
No blinking
during charge
process, no
function of tiller-
display during
charge process
Faulty Contact Torqeedo Service.