Repeat Last Number Dialed:
+ (or
Message Waiting:
Saved Number
To save: Number
To use:
To set: Number
Toanswer: or
To cancel (calling station):
Number t or Number
and # Tone Dialing:
To enable: To cancel (called station): or
Paging:
Call Forward:
To set:
q
(or Number
t q
)
To cancel:
q
To page (handset off-hook):
= All stations
Call Pickup:
To pick-up a call ringing or on hold:
(or
q
) Station Number
To pick-up paging (or +
= All Call
= External Page
Any CO line ringing
Conference Calls:
To add a CO line to an existing call:
Number (wait for answer)
= Station Groups 1 4
All stations (with External Page)
= External Page
= All station plus all external zones
CO Line Privacy Release:
To set: (LED on)
To cancel: (LED off)
Microphones Cut-Off (MCO):
To set: (LED on)
To cancel: (LED off)
Tone/Pulse Sending:
to an existing call:
Number (wait for answer)
.
to add station(s)
Tandem CO Line Connection (CO-to-CO):
To connect a CO call to an existing CO call:
To use tones:
(LED
on)
To use Dial Pulse: (LED off)
Toll Restriction Override:
To use: + + code + Number
Account Code:
Number (wait for answer)
l
hang up
Do Not Disturb:
To set: (LED on)
To Cancel: (LED off)
Call Transfer with Camp-On:
To transfer: Number
Hold:
To set: (or
l
)
To recall: (flashing LED) or (if CO line is
not on station)
Exclusive Hold:
To set:
To recall: (flashing LED)
Forced: Account code Number
Voluntary (call in progress): +
+ Account code
Voice Mail:
See the manufacturer’s literature for instructions on
using Voice Mail. The following instructions may vary
slightly, depending upon the Voice Mail system used.
Call Forward: Whenever your station is call forwarded
to voice mail, additional digits are automatically
sent to the voice mail unit to direct the call to
your voice mailbox. To store these digits, depress
Mailbox number
Message Waiting: When you retrieve your messages
from voice mail additional digits are
automatically sent to the voice mail unit to play-
back your messages. To store these digits, depress
voice mailbox number and message
retrieval sequence
Override or Off-Hook Call Announce:
The above procedures are required only once for the
If busy or initial voice mail set-up. The stored digits are sent only
*Override only
on voice mail calls.