
8
Register online at www.towerhousewares.co.uk for your FREE extended guarantee.
3USINGYOURAPPLIANCE
Assembly:
CAUTION: Do not plug the product into an
electrical outlet until it is fully assembled.
Before using the product for the rst time,
disassemble and wash as follows:
1. Unscrew the blade assembly from the cup
and carefully remove the gasket from its
groove.
CAUTION: Handle blades carefully, as they are
sharp.
2. Wash all parts except the base and power
cord in warm, soapy water or place them
in the top rack of an automatic dishwasher,
then rinse and dry thoroughly.
WARNING: Do not immerse the base or power
cord in water or other liquids.
NOTE: Do not use abrasive cleaners to clean
any part of the product.
3. Insert the gasket into the groove in the
blade assembly and securely retighten
the blade assembly onto the top of the
cup. Note that the lip of the gasket faces
upward.
NOTE: When inserting the gasket into the
groove, press the gasket rmly around all sides
and test it by turning the blade assembly upside
down to make sure the gasket is not loose or
does not fall out. There will be a small bump
underneath the gasket where the safety interlock
mechanism protrudes; this is normal.
4. Place the base on a at, level, stable
surface. To attach the cup assembly (with
the cup and the blade assembly securely
attached together), align the symbol on
the bottom edge of the blade assembly with
the mark on the base and turn clockwise
until it is rmly in place, aligned with the
symbol.
Usingyourappliance:
1. Ensure the power cord is unplugged from
the electrical outlet, then remove the cup
assembly from the base and unscrew the
blade assembly.
2. Pour any liquid ingredients into your
Personal Blender cup rst, to help lubricate
the blades. Cut all solid ingredients into
small pieces.
3. Ensure the gasket is securely seated in the
blade assembly, and then securely tighten
the blade assembly clockwise onto the top
of the cup.
4. To attach the cup to the Personal Blender
base, align the symbol on the bottom
edge of the blade assembly with the
mark on the base and turn clockwise until it
is rmly in place, aligned with the symbol.
NOTE: Product will not operate and ready light
will not illuminate unless both the cup and blade
assembly are attached properly to the base.
5. Plug in your Personal Blender. The power
indicating light will illuminate.
6. Press the power button to start blending.
NOTE: If the blades are not operating smoothly,
stop the product and add some liquid, or reduce
the solid contents in the cup.
7. Press the power button again to shut the
blender off.
8. When the blades have stopped, unplug
the power cord from the electrical outlet,
remove the cup from the base, and turn the
cup right-side up.
9. Unscrew the blade assembly from the cup
and empty the contents into a separate
container or screw a drinking lid onto your
cup to enjoy your smoothie on the go!