Travis Industries 564 User manual

564 Grill Installation
SKU # 96200801, 96200803, 96200805
Page 1 of 3 17601471 - 1/30/14 © Travis Ind. 17601471
Compatibility:
• 564 Fireplaces
Packing List:
• Upper and Lower Grill
Installation:
NOTE: The glass frame should be in place before installing the grills.
1 The 564 SS will require some slight modifications to allow the upper grill to fit into place. Follow the directions
below to re-position the center deflectors and verify the heat shield support.
Remove the two center deflectors (use
needle-nose pliers if necessary).
These tabs bend down
to allow for removal.
NOTE: Make sure this heat
shield support is in place (it
prevents the lower shield
from sagging).
Re-attach the deflectors to the
top louver on both sides of the
notch. Bend the tabs as shown,
making sure the deflectors are
secure and flat.
The center deflectors must be in place if using an optional face to prevent the facing above the
fireplace from becoming too hot. Make sure the deflectors are secured to the top louver (see the
illustration above).

564 Grill Installation
SKU # 96200801, 96200803, 96200805
Page 2 of 3 17601471 - 1/30/14 © Travis Ind. 17601471
2 Follow the directions below to install the grills.
Hold the grill at an angle and insert the lower
slot over the bushing on the fireplace (both
sides). You may need to press on the grill to
get the tab over the bushing (this prevents
the grill from accidentally falling off).
Bend the tab over on both
sides. This is the end-stop
for the lower grill, it allows
the grill to swing forward.
Swing the grill upwards to engage
the upper slot. You will need to lift
the grill slightly to get it over the
bushing. Once in place the grill is
held in place by gravity.
UPPER GRILL INSTALLATION
NOTE: The upper grill is difficult to install the first time - be patient, after you install it, you will know
how it installs and it will be much easier the second time.


Position the grill
so the slots on
the grill align with
the mounting
studs.
You may need to
push in and
upwards on the
grill as it inserts.
The grill, when
fully inserted,
will slide down
and “click” into
place.
Upper Grill
Heat Shields
(on fireplace)
Mounting Stud
SIDE VIEW
LOWER GRILL INSTALLATION



564 Grill Installation
SKU # 96200801, 96200803, 96200805
Page 3 of 3 17601471 - 1/30/14 © Travis Ind. 17601471
NAMEPLATE INSTALLATION:
On certain models the nameplate is shipped loose. Attach the appropriate nameplate following
the instructions below
Attach the nameplate to the
tab on the lower grill.