TreeTop Products BC2315 User manual

Rev #1
11/20/23
Backless Silhouette Bench
BC2315

12
1/4" Flat Washer
12
1/4" x 1.5" Lag Screw
4
Seat Slat
3
Inground Bench End
REQUIRED TOOLS:
-(1) SCREW GUN
-(1) 7/16" SOCKET
-(1) 8" - 10" POSE HOLE DIGGER
-(1) LEVEL
REQUIRED MATERIALS:
-READY-TO-MIX-CONCRETE
-LOOSE GRAVEL
-WIRE & BRACING MATERIAL
Backless Silhouette Bench
BC2315
2/6
INCLUDED HARDWARE &
TOOLS REQUIRED FOR
ASSEMBLY

NOTE
: Make sure BOTH ends of the bench
are square before fully tightening everything
down. If possible, secure one of the short
ends of the bench against a wall or other
flat surface.
1
Assembly:
Place the seat slats with the pilot holes facing •
up off the ground.
Line up the holes on the bench end with the pilot •
holes on the seat slats.
Secure the bench ends to the seat with the •
included washers and lag screws.
KEEP BOARD SPACING
APPROXIMATELY 1/2"
Backless Silhouette Bench
BC2315
3/6

28.00
(8" - 10" DIAMETER)
4.00
24.00 4FT BENCH
12.00 12.00
LOOSE GRAVEL
USING POST HOLE DIGGER, DIG THREE HOLES AS SHOWN BELOW. THEN, FILL IN EACH HOLE
WITH APPROXIMATELY 4" OF
LOOSE GRAVEL.
BEFORE INSTALLING BENCH, PLEASE CHECK LOCAL CODES TO ENSURE PROPER
INSTALLATION. THESE INSTRUCTIONS ARE A GENERAL GUIDELINE ON HOW TO
INSTALL A BENCH. IF UNSURE ON HOW TO INSTALL, PLEASE CONTACT A
PROFESSIONAL.
2
Backless Silhouette Bench
BC2315
4/6

24.00
16.75
24.00
CAREFULLY, PLACE THE BENCH INTO HOLES. CENTER EACH POST IN EACH HOLE AND
LEVEL BENCH. ALSO, BE SURE TO CHECK SEAT HEIGHT TO ENSURE COMFORTABLE
SEATING. SECURE PLACEMENT OF BENCH WITH BRACING MATERIALS AND FILL IN
HOLES WITH READY-TO-MIX CONCRETE. ALLOW TO DRY AND REMOVE BRACING
MATERIALS.
BEFORE INSTALLING BENCH, PLEASE CHECK LOCAL CODES TO ENSURE PROPER
INSTALLATION. THESE INSTRUCTIONS ARE A GENERAL GUIDELINE ON HOW TO
INSTALL A BENCH. IF UNSURE ON HOW TO INSTALL, PLEASE CONTACT A
PROFESSIONAL.
LOOSE
GRAVEL
3
Backless Silhouette Bench
BC2315
5/6