Troy-Bilt 20241 User manual

O®
d
Pressure Washer /Lavadora de Presi6n
Modem /Modemo 02024m
Before using this product, read this manuaHand follow aH Antes de utiHizareHproducto, Heaeste manuaHy siga todas Has
Safety RuHesand Operating Instructions. Reghs de Seguridad e Instrucdones de Usa.
Questions_ Preguntas_ Helpline - 1-888-611-6708 P1-F8-5 CT
Troy-Bilge.)is a registered trademark ofTroy-Bilt, LLC and is used under license to Briggs & Stratton Power Products.
Troy-Bilt® es una marca registrada de Troy-Bilt, LLC y se usa abaio licencia a Briggs & Stratton Power Products.
BRJGGS & STRATTON POWER PRODUCTS GROUP, LLC
JEFFERSON,WiSCONSiN, U.S.A.
Printed in USA Manual No. 196019GS Revision 0 (I 2/I 5/2004)
5

Safety Rules
SAVE THESE INSTRUCTIONS
TABLE OF CONTENTS
Section H oSafety Rules .......................... 2-4
Section 2 - Features and ControHs ................... S
Section 3 o AssembHy ............................ 6-8
Section 4 o Operation .......................... 9- H2
Section 5 o Maintenance ........................ H3oH5
Section 6 o Storage .............................. H6
Section 7 oTroubleshooting ........................ H7
Notes ......................................... H8
Warranty ...................................... H9
EQUIPNENT
-7 Read this manuamcarefummyand become famimiar
pressure washer. Know its
Jwith
...... your
appmications,its mimitations _d any hazards
invomved,
This manuaH contains information for a high pressure
washer that operates at 2,600 PSI at a flow rate of
2.5 gaHHons per minute.This powerful high quality system
features Harge H0" wheeHs, a pump equipped with an
automatic cooH down system, chemicaH iniection system,
nozzHe extension with quick connect nozzHes, safety go_Hes,
heavy duty 25' hose, and more.
Every effort has been made to ensure that information in
this manuaH is accurate and current. However, we reserve
the right to change, alter or otherwise improve the
product and this document at any time without prior
notice.
SAFETY RULES
This is the safety amert symbom, it is used to
amert you to potentiam personam injury
hazards. Obey atomsafety messages that fommow
this symbom to avoid possibme iniury or death.
The safety aHert symboH (_) is used with a signaHword
(DANGER, CAUTION,WARNING), a pictoriaH and/or a
safety message to aHert you to hazards. DANGER indicates
a hazard which, if not avoided, will resuHt in death or serious
injury. WARNING indicates a hazard which, if not
avoided, could resuHt in death or serious injury. CAUTION
indicates a hazard which, if not avoided, might resuHt in
minor or moderate injury. CAUTION, when used
without the aHert symbol indicates a situation that couHd
resuHt in equipment damage. FoHHowsafety messages to
avoid or reduce the risk of injury or death.
Hazard Symbols and Meanings
Toxic Fumes
Slippery Surface
Fire
Fall
Explosion
Electrical Shock
Fluid Hniection
Hot Surface
Moving Parts Flying Obiects Kickback

Section 1: Safety Rules
WARNING
Operate pressure washer ONLY outdoors,
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
DO NOT operate pressure washer inside any building or
enclosure.
Use a respirator or mask whenever there is a chance that
vapors may be inhaled,
Read all instructions with mask so you are certain the mask wilI
provide the necessary protection against inhaling harmful vapors,
WARNING
Keep spray nozzle between 8 to 24 inches away from cleaning
SUY{ace,
Operate this unit on a stable surface.
The cleaning area should have adequate slopes and drainage to
reduce the possibility of a fall due to slippery surfaces.
Be extremely careful if you must use the pressure washer from
a ladder; scaffolding or any other relatively unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid iniury if gun kicks back,
WARNING
When starting engine, pull cord slow,Jy until resistance is felt
and then pull rapidly to avoid kickback.
If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun,
WARNING
WHEN ADDING FUEL
Turn pressure washer OFF and let it cool at least 2 minutes
before removing fuel cap.
Fill fiJeI tank outdoors.
DO NOT over{ill tank.AIIow space for fuel expansion.
Keep fueI away from sparks, open flames, pilot lights, heat, and
other ignition sources.
DO NOT light a cigarette or smoke.
VHEN OPERATmNG EQUmPMENT
• Transport/repair with fuel tank EPIPTY or with fuel shutoff
valve OFE
WHEN STORING FUEL OR EQUIPMENT WiTH FUEL
iN TANK
Store away from furnaces, stoves, water heaters, clothes
dryers or other appliances that have pilot light or other
ignition source because they can ignite fuel vapors.
WARNING
NEVER aim spray gun at people, animals or plants,
DO NOT allow CHILDREN to operate pressure washem
NEVER repair" high pressure hose, Replace it.
Keep high pressure hose connected to pump and spray gun
while systemis pressurized,
Squeezetrigger on spray gunto relieve trapped pressure,
every time you stop engine. Engagetrigger lock on spraygun.
WARNING
Keep water spray away from electric wiring or fatal electric
shock may result.

Section 1: Safety Rules
WARNING
DO NOT touch hot surfaces.
Allow equipment to coo[ before touching.
The pressure washer must be at [east 5 feet from structures
having combustible wails and/or other combustible materials.
Keep at least 3feet of clearance on all sides of pressure
washer for" adequate cooling, maintenance and servicing.
In the State of California a spark arrester is required by law
(Section 4442 of the California PuNic Resources Code). Other
states may have similar Jaws. Federal laws apply on federal
lands. If you equip the muffler with a spark arrester; it must be
maintained in effective working orden
WARNING
. DO NOT wear loose clothing, ieweiry or anything that may
be caught in the starter or" other rotating parts.
. Tie up long hair and remove ]ewelD:
WARNING
Always wear eye protection when using this equipment or in
vicinity of where equipment is in use,
WARNING 1
WHEN ADJUSTING OR MAKING REPAiRSTOYOUR
PRESSURE WASHER
Disconnect spark plug wire from spark plug and place wire
where it cannot contact spark plug.
CAUTION
DO NOT tamper with governed speed.
DO NOT operate pressure washer above rated pressure.
CAUTION
DO NOT secure spray gun in open position.
DO NOT leave spray gun unattended while machine is
running.
NEVER use a spray gun which does not have a trigger lock or
trigger guard in place and in working order:
Always be certain spray gun, nozzles and accessories are
correctly attached.
DO NOT point spray gun at glass when using MAX (pin
point) nozzle,
NEVER aim spray gun at plants.
If you have questions about intended use, ask dealer or
contact Briggs & Stratton Power Products.
NEVER operate units with broken or missing parts, or
without protective housing or covers.
DO NOT by-pass any safety device on this machine.
Before starting pressure washer in cold weather, check all
parts of the equipment to be sure ice has not formed there.
NEVER move machine by pulling on high pressure hose. Use
handle provided on unit.
Check fuel system for leaks or"signs of deterioration, such as
chafed or" spongy hose, loose or missing damps, or damaged
tank or cap. Correct all defects before operating pressure
washerL
This equipment is designed to be used with Briggs & Stratton
Power Products authorized parts ONLY. ff equipment is used
with parts that DO NOT comply with minimum specificadons,
user assumes all risks and liabilities.

Features and Controls
KNOWYOUR PRESSURE WASHER
Read this owner's manua[ and safety fumes before operating your pressure washer,
Compare the Hhstradons with your pressure washer to familiarize yourseff with the [ocaqons of various controls and
adjustments. Save this manual for future reference.
AccessoryTray Pump equipped with
Automatic Cool Down System Air Filter
Throttle Lever
Choke Rod
Recoil Starter
front of engine)
FuelTank
Spray Gun
Connect
High Pressure Hose
DataTag
SprayTips
VVater Inlet
Chemical Injection
AccessoryTray -- Provides convenient storage for
standard and optional accessories, such as brushes, turbo
wands, etc.
Air Fitter -- Protects engine by filtering dust and debris out
of intake air.
Automatic Coot Down System -- Cycles water through
pump when water reaches 125 °° [55°EWarm water wii[
discharge from pump onto ground.This system prevents
internal pump damage.
Chemical Injection SiphonlFilter -- Use to siphon
detergent or other pressure washer chemicals into the low
pressure stream.
Choke Rod -- Prepares a cold engine for starting.
DataTag -- Provides model revision and serial number of
pressure washer. Please have these readily available if calling
for assistance.
Fuel Tank -- Fill tank with regular unleaded fuel.Always leave
room for fuel expansion.
Oil Fiii Cap
"_ Pressure Outlet
High
High Pressure Hose -- Connect one end to the water
pump and the other end to the spray gun.
Hi[[h Pressure Outlet --To connect high pressure hose.
Nozzle Extension with Quick Connect -- Allows you to
switch between four different spray tips.
Oil Fill Cap -- Fill engine with oil here.
Pump -- Develops high pressure.
Recoil Starter -- Use for starting the engine manually.
Safety Goggles (not shown) -- Always use the enclosed
goggles or other eye protection when running your
pressure washer.
Spray Gun -- Controls the application of water onto
cleaning surface with trigger device. [nchdes triter lock.
SprayTips -- Chemical injection, 0°,[5 °, and 40°:for various
high pressure cleaning appiications_
Throttle Lever--Sets engine in starting mode for recoil
starter and stops a running engine.
Water Inlet -- Connect garden hose here.