Truvox Hydromist 35 User manual

UK-HM35-REV.00 (0218)
Hydromist 35 User Guide
THIS USER GUIDE SHOULD ALWAYS BE USED IN CONJUNCTION WITH THE USER MANUAL
Fill the fresh water solution tank
with mixed water and approved
cleaning chemical according to the
chemical manufacturer’s
instructions.
Press and hold the solution switch
to apply the cleaning solution,
whilst pulling the machine slowly
backwards to clean the carpet.
Stop spraying the cleaning solution
about 30cm before the end of the
cleaning pass to ensure all
solution is vacuumed up.
Wheel the machine forward and
repeat, slightly overlapping the
previous pass. Do not clean any area
more than twice, or overwetting
could result in carpets shrinking.
1. Preparing the machine
2. Using the machine
Fully unwind the supply cord and
plug in to a convenient socket
outlet.
To lower the floating brush, press
the foot pedal.
Switch on the vacuum motor,
pump and brush switches.

UK-HM35-REV.00 (0218)
After a few passes, check the
waste tank to see that no foam is
present. Add extra defoamer if
necessary.
Make sure to empty the recovery
tank when it is approximately ¾
full. Do not refill the solution tank
without emptying all the contents
of the recovery tank first.
When solution spray ceases the
solution tank is empty. Switch off
the machine, empty the recovery
tank and refill the solution tank.
If using these accessories, connect
the vacuum and solution hose to
the front of the machine.
Attach the upholstery tool to
both the vacuum and solution
hose on the other end.
There is an optional upholstery kit
and stair cleaning attachment
available.
3. Using the optional upholstery tools
Switch on the vacuum motor and
pump switch.
Operate the spray lever on the
handle to dispense the cleaning
solution whilst pulling the
upholstery tool or wand
backwards.

UK-HM35-REV.00 (0218)
Switch OFF all switches and
unplug the machine.
Wrap supply cord around handle
ensuring that plug is not trailing
on the floor.
Add approx. ½ litre of clean
water to solution tank to flush out
the tank and pump. Once draining
is finished, remove the drain hose.
4. After use and storage
After use, run the vacuum motor
for approximately 2 minutes.
Ensure all switches are in the
OFF position.
To drain the recovery tank,
release the drain hose at the rear
of the machine and empty into a
bucket. Rinse out the tank with
clean water to remove dirt and
sediment.
2 min
Regularly check the filter by
removing and rinsing out any dirt
or debris.
To drain the solution tank: connect
the drain hose to the solution fitting
at the front of the machine and
direct the free end into a bucket.
Turn on the PUMP switch. This
will pump out any remaining
solution.

UK-HM35-REV.00 (0218)
With both water tanks empty the
machine may be tilted backwards
to rest on the handle to facilitate
cleaning. Wipe down the machine,
including the underside of the
machine.
Check the vacuum and brush for
debris. The brush should be raised
for storage.
Store the machine with the
recovery tank lid removed and
store in a dry indoor area only.