TUISS Twist2Fit User manual

Installation Guide
Twist2Fit™Roller Blinds
Fitting the blind
Insert the blind into the recess at an angle and push the
tightener against the wall.
Lift the control end of the blind until level and release
pressure, the blind will hold itself in place.
Make adjustments to the position of the blind so that it is straight and level, before locking it in place.
Left Control
Tightener on the right
Right Control
Tightener on the left
Hold the blind securely in place and turn the
tightening wheel to tighten the blind in place.
Turn the wheel clockwise relative to the roller tube.
Left Control
Tightener on the right
Right Control
Tightener on the left
Once the blind is secured in place, turn the end cap
until it locks against the tightening wheel. This will
lock the tightening wheel in place.
Turn the cap anti-clockwise relative to the roller
tube.
Top Tip
Make sure that you tighten the wheel as much as you possibly can so that the blind remains secure and does not slip.

The cord retaining device must be installed at the
maximum distance possible from the control
mechanism to prevent looped cords from becoming
slack.
Place the retaining device on the wall and mark the
position of the screw hole(s) with a pencil.
Attach the retaining device to the wall using the
fixings provided.
Child Safety
Cord Tensioner
Installation Guide
Twist2Fit™Roller Blinds