Turbo Energy Lithium Slim Series User manual

www.turbo-e.com
Quick Installation Guide
Lithium Series Slim
48V 2.4 kWh + Goodwe Inverter
10
AÑOS
TURBO ENERGY
WARRANTY

www.turbo-e.com
1. Goodwe Inverter configuration (Wifi)
First, the inverter must be configured properly. For this, a correct Wi-Fi connection must be made
between the electronic device and the inverter, as well as a correct configuration through the PV
Master application.
To make a correct Wi-Fi connection, follow these steps:
Note: This connection can also be made from the PV Master app.

www.turbo-e.com
2. Goodwe Inverter configuration (PV Máster)
PV Master is an external monitoring / configuration application for hybrid inverters. It can be
downloaded directly from the Play Store or App Store and works with both Android and iOS
systems.
Once it has been successfully connected to the inverter's Wi-Fi network, the application must be
configured according to the batteries to be connected.
First it is necessary to select the country where the device is located. To do this, you need to enter
the basic configuration tab and select the option shown in the following images:
Next, you need to select the working mode to be used. You must choose one of the four options that
appear: General Mode, Off-Grid Mode, Back-Up Mode, Economical Mode.
Finally, the type of battery to be used must be selected. For
this, the following option must be selected regardless of
whether it is going to work with one or more batteries.

www.turbo-e.com
3. Battery configuration
Each module has 4 DIP (Dual Inline Package) switches that will be configured differently
depending on the number of batteries to be connected.
They are configured according to the binary code, starting with the master.
Address
Dial switch position
Explain
Dip
#1
#2
#3
#4
1
ON
OF
F
OFF
OFF
Pack1/Master
2
OFF
ON
OFF
OFF
Pack2
3
ON
ON
OFF
OFF
Pack3
4
OFF
OF
F
ON
OFF
Pack4
5
ON
OF
F
ON
OFF
Pack5
6
OFF
ON
ON
OFF
Pack6
7
ON
ON
ON
OFF
Pack7
8
OFF
OF
F
OFF
ON
Pack8
9
ON
OF
F
OFF
ON
Pack9
10
OFF
ON
OFF
ON
Pack10
11
ON
ON
OFF
ON
Pack11
12
OFF
OF
F
ON
ON
Pack12
13
ON
OF
F
ON
ON
Pack13
14
OFF
ON
ON
ON
Pack14
15
ON
ON
ON
ON
Pack15
Cualquier cambio que se realice en los DIPs se ha de realizar con la batería apagada.
Cuando la batería trabaja por tensión, no es necesario comunicar las baterías entre sí ni seleccionar
una configuración de DIPs determinada
1=ON
0=OFF
1
3
2
4

www.turbo-e.com
4. Configuración CABLEADO
The cable necessary to make the connection is the RJ45. It is a special
cable that is made up of 8 smaller cables each with a different color
configuration.
It will be needed a PIN to PIN standar with RJ45 connector.
PRECAUCIÓN: LEA EL MANUAL DE INSTRUCCIONES E INSTALACIÓN ANTES DE USAR EL PRODUCTO
©Copyright 2020. Todos los derechos reservados.
Las especificaciones de la ficha técnica pueden ser cambiadas sin previo aviso.
Connect the cable
to the CAN-1
battery port
Inverter Battery