Ubiquiti LTU-LR User manual

5 GHz LTU™Long-Range
Client Radio
Model: LTU-LR

• Package Contents
• Installation Requirements
• Hardware Overview
• Hardware Installation
• Connecting Power
• Accessing the Configuration Interface
• UNMS Management
• Installer Compliance Responsibility
• Specifications
• Safety Notices
• Electrical Safety Information
• Limited Warranty
• Compliance
• Declaration of Conformity
• Online Resources

Package Contents
Antenna Feed Center Reflector
Panel
Side Reflector Panels
(Qty. 2)
0
0
Mounting Bracket Rear Housing Pivot Panels
(Qty. 2)
M4 SEM
Screws
(Qty. 8)
M8 SEM
Screws
(Qty. 4)
Metal Straps
(Qty. 3)
Gigabit PoE
(24V, 0.5A)
with Mounting Bracket
Power Cord
Installation Requirements
• LTU PtMP AP, such as model LTU-Rocket
• Phillips screwdriver
• 13 mm wrench
• 8 mm socket wrench or screwdriver

• Surge protection should be used for all outdoor installations.
We recommend that you use two Ethernet Surge Protectors,
model ETH-SP-G2, one near the device and the other at
the entry point to the building. The ETH-SP-G2 will absorb
power surges and safely discharge them into the ground.
Note: For guidelines about grounding and lightning
protection, follow your local electrical regulatory
codes.
LAN
≤1 m
ETH-SP-G2
ETH-SP-G2
ES-8-150W
LTU-LR
• Outdoor, shielded Category 6 (or above) cabling and
shielded RJ45 connectors are required for all wired Ethernet
connections.

Hardware Overview
Bottom View
2
3
4
1
LAN LED The LED will light steady blue when an active
Ethernet connection is made to the Ethernet port and flash
when there is activity.
Power LED The LED will light blue when the device is
connected to a power source.
Reset Button To reset to factory defaults, press and hold the
Reset button for more than 10 seconds while the device is
poweredon.
PoE In [24V] Port This 10/100/1000 Ethernet port is used
to connect the power and should be connected to the LAN.
Default IP address: 192.168.1.20

Hardware Installation
1.

2.

3.